Loading ...
Loading ...
Loading ...
6
Cooking compartment
The cooking compartment has four shelf heights. The shelf
positions are counted from the bottom up.
Caution!
■ Do not place anything on the cooking compartment floor. Do
not cover it with aluminium foil. A build-up of heat could
damage the appliance.
The cooking compartment floor and the evaporator dish must
always be kept clear. Always place ovenware in a perforated
cooking container or on a wire rack.
■ Do not slide any accessories between the shelf positions, or
they may tip.
Accessories
Use only the accessories supplied with the product or available
from the after-sales service. They are specially designed for
your appliance.
Your appliance is equipped with the following accessories:
You can obtain further accessories from specialist retailers:
Automatic calibration
The boiling temperature of water depends on the air pressure.
During calibration, the appliance is adapted to the pressure
conditions in the location where it is installed. This happens
automatically when you first use the appliance (see section:
First use). More steam develops than usual.
It is important that the appliance steams without interruption for
20 minutes at 100 °C. Do not open the appliance door during
this time.
If the appliance was not able to calibrate itself automatically (for
example, because the appliance door was opened), the
calibration process is carried out again during the next cooking
operation.
After moving house
So that the appliance automatically adjusts itself to its new
location, you must reset the appliance to the factory settings
(see section: Basic settings) and repeat the initial start-up
process (see section: First use).
After a power cut
The appliance saves the calibration settings even in the event
of a power cut or disconnection from the mains. Recalibration
is not necessary.
Before using for the first time
In this section you will find out which steps are required before
using the appliance for the first time:
■ Setting the clock
■ Setting the water hardness range
■ Starting the appliance for the first time
■ Cleaning the accessories before use
Setting the clock
After the power has been connected, the0 symbol and ‹‹:‹‹
light up in the display. Set the clock.
1.Press the 0 button.
The time
‚ƒ:‹‹ is shown in the display.
2.Use the @ or A button to set the clock.
After a few seconds, the time which has been set is adopted.
Setting the water hardness range
Descale your appliance regularly. This is the only way to
prevent damage.
Your appliance automatically displays when it needs descaling.
It has been preset to water hardness range "medium". Change
the value if your water is softer or harder.
You can check the water hardness with the test strips supplied
or ask your water supplier.
If your water is very hard, we recommend that you use softened
water.
You can only dispense with descaling completely if you
exclusively use softened water. If this is the case, change the
water hardness to "softened".
You can change the water hardness range in the basic settings
when the appliance is switched off.
1.If required, turn the operating mode selector to Û to switch off
the appliance.
2.Press and hold the0 button until ™‹ „ appears in the
display.
Cooking container, solid, GN
Z,
40 mm deep
For catching dripping liquid when
steaming and for cooking rice,
pulses and cereals
Cooking container, perforated,
GN
Z, 40 mm deep
for the steaming of whole fish or
large quantities of vegetables, for
juicing berries, etc.
(YDSRUDWRUGLVK
5DLOVIRU
WKHDFFHVVRULHV
:DWHUWDQN
Accessories Order no.
Cooking container, solid, GN
Z, 40 mm
deep
HEZ36D353
Cooking container, perforated, GN
Z,
40 mm deep
HEZ36D353G
Cooking container, solid, GN
Z, 28 mm
deep (baking tray)
HEZ36D352
Cooking container, solid, GN
Y, 40 mm
deep
HEZ36D153
Cooking container, perforated, GN
Y,
40 mm deep
HEZ36D153G
Wire rack HEZ36DR
Cleaning sponge 643 254
Descaler 311 138
Honeycomb microfibre cloth 460 770
Loading ...
Loading ...
Loading ...