Loading ...
Loading ...
Loading ...
5
4. When 1 cup of water has been correctly dispensed into the
measuring cup, press the MEASURED FILL button under the word
“Conrm” to conrm the calibration.
When Measured Fill calibration has been conrmed the icons will
disappear and the display will return to the home screen.
Dispensing
Press ICE/WATER to toggle through the following choices in a
continuous loop:
J Water (default) - Dispenses water
J Cubed - Dispenses cubed ice
J Crushed - Dispenses crushed ice
NOTE:
J The word “ICE” appears on the display screen when either
crushed or cubed ice is selected.
J For crushed ice, cubes are crushed before being dispensed.
This may cause a slight delay when dispensing crushed ice.
Noise from the ice crusher is normal, and pieces of ice may
vary in size.
J When changing from crushed to cubed, a few ounces of
crushed ice will be dispensed along with the rst cubes.
The Water Dispenser
IMPORTANT:
J Dispense at least 1 qt (1 L) of water every week to maintain a fresh
supply.
J If the ow of water from the dispenser decreases, it could be
caused by low water pressure.
J With the water lter removed, dispense 1 cup of water. If 1 cup
of water is dispensed in 8 seconds or less, the water pressure
to the refrigerator meets the minimum requirement.
J If it takes longer than 8 seconds to dispense 1 cup of water, the
water pressure to the refrigerator is lower than recommended.
See “Water Supply Requirements” and “Troubleshooting” for
suggestions.
To Dispense Water (Standard):
1. Press a sturdy glass against the dispenser paddle.
2. Remove the glass to stop dispensing.
To Dispense Water (Measured Fill):
Measured Fill allows you to dispense a specied amount of water with
the touch of a few controls.
NOTE: The amount of water you select will be dispensed. Make sure
that the container is empty and can hold the entire volume. If ice is in
the container, you may need to adjust your selection.
1. Press MEASURED FILL to turn on the feature. When the feature is
on, the Measured Fill screen appears on the display.
Press ICE/WATER to manually turn off the Measured Fill feature.
NOTE: The dispenser will automatically turn off Measured Fill after
1 minute of inactivity.
2. You can dispense water by the ounce, cup or liter. The default unit
is ounces. To switch to cups or liters, press the LIGHT button.
Default, minimum, and maximum volumes are listed below.
Units Default Minimum Maximum
Ounces 8 1 128
Cups 1 1/4 16
Liters 0.25 0.05 4.00
3. Press LOCK or OPTIONS to adjust the water volume as desired.
The LOCK control increases the volume, and the OPTIONS control
lowers the volume.
NOTE: Most coffee cups (commonly 4 to 6 oz [118 to 177 mL] per
cup) are not the same size as a measuring cup (8 oz [237 mL]). You
may need to adjust the volume to avoid unintentionally overlling
coffee cups.
4. To dispense water, press sturdy glass against the water dispenser
lever OR place the glass below the water dispenser and press the
MEASURED FILL button.
NOTE: While dispensing water, the digital display will count down
how much water remains to be dispensed, according to the
volume you selected. The ow of water will automatically stop
once the desired volume has been dispensed.
5. To stop dispensing before the selected volume has been
dispensed, remove the glass from the dispenser paddle OR press
MEASURED FILL a second time.
NOTE: If you stop dispensing before the desired volume has been
dispensed, the digital display will continue to show how much
water remains to be dispensed. The display will turn off after 1
minute of inactivity.
6. To select a new volume or start dispensing the same volume
again, you must rst nish dispensing the selected volume, or turn
off the Measured Fill feature (either by waiting 1 minute so it will
automatically turn off or by pressing ICE/WATER, under Back, to
manually turn it off) and then turn it back on.
The Ice Dispenser
Ice dispenses from the ice maker storage bin. To turn off the ice maker,
see “Ice Maker and Storage Bin.”
The dispenser may continue to make noise and ice may continue to
dispense for several seconds after releasing the dispenser button or
paddle.
IMPORTANT: If the ice cubes are hollow or have an irregular shape,
it could be because of low water pressure. See “Water Supply
Requirements” in the Installation Instructions and Problem Solver.
A
A. 1 cup of water
Water Crushed Cubed
Loading ...
Loading ...
Loading ...