Loading ...
Loading ...
Loading ...
10 GB
1-
2-
3-
4-
5-
6-
7-
8-
9-
10-
11-
12-
13-
14-
15-
Cook top
Control panel
Drawer
Oven door (Front door)
Metallic top lid or Glass top lid
Auxilary burner
Rapid burner
Hot plate
Hot plate
Right grate
Burners control knobs
Hot plates control knobs
Thermostat oven knob
Ignition button or fan button
Signal lamp
1-
2-
3-
4-
5-
6-
7-
8-
9-
10-
Cook top
Control panel
Drawer
Oven door (Front door)
Metallic top lid or Glass top lid
Hot plate
Hot plate
Hot plate control knobs
Thermostat oven knob
Signal lamp
3. USE OF COOKTOP BURNERS
The knobs which control the burners are positioned on the control panel.
Off Position
When the knob is turned so that the 'dot' symbol faces towards the
panel, it is in the Off position and the gas valve is closed and the
flame will go out.
Maximum Gas Flow
Press the burner knob and turn it to the left till the 'dot' symbol faces
towards the large flame symbol.
The flame is on full at this position.
In this position, the gas valve is completely open.
Minimum Gas Flow
The flame can be decreased by turning the knob so that the 'dot'
symbol faces towards the small flame symbol. The valve will be
partially open and the burner will then be on low.
3.1. GAS BURNERSUSE OF COOKTOP
Figure 7
A
B - Burner
C - Electrode
D - Injector ( Jet )
E - Burner body
F - Safety device
- Burner Lid
A
B
C
D
E
F
Figure 8
Ignition of the Burners
Cooktop Gas Burners
The burner must be ignited before a pan is placed over it.
For models with automatic ignition, the 'spark' button must be pressed.
Press the knob controlling the burner you want to ignite and then turn it left
to the big flame symbol. Press the ignition button. On models with ignition-
thru knobs, press and turn the knob controlling the burner you want to
ignite as far as the star symbol; the electrode will be automatically
activated. All the electrodes will be activated automatically and the burner
to which gas is supplied (that relative to the knob pressed) will ignite.
Oven Gas Burners
The button must not be kept pressed down for more than 15 sec. If the
burner has not ignited after 15 sec. release the button and open the
compartment door and/or wait at least 1min. before attempting again. For
other models the gas is ignited by means of the control knobs.
Make sure that the gas is actually burning after this
step! If there is no flame, repeat the procedure
REMOVING AND CLEANING WIRE RACKS
1- Remove the wire racks by pulling them in the
direction of the arrows (see below)
2- To clean the wire racks either put them in the
dishwasher or use a wet sponge, ensuring that they
are dried afterwards.
3- After the cleaning process install the wire racks in
reverse order.
5
4
3
2
1
Loading ...
Loading ...
Loading ...