Loading ...
Loading ...
Loading ...
8
3. Remove the lower freezer drawer (C) by
lifting it up.
4. Remove the 4 screws attached to the
supporting frame (D).
5. Pull out the freezer door and lift it up in
the direction of the arrow.
Re-assembling the freezer door
To reattach the drawer after you moved
the appliance to its final location,
assemble the parts in reverse order.
Installing the water lines and filter (Only
applicable for models with ice maker)
A water dispenser with a filter is one of the
helpful features on your new appliance. To
help promote better health, the water filter
removes unwanted particles from your
water. However, it does not sterilize or
destroy microorganisms. You may need to
purchase a water purifying system to do
that.
In order for the ice maker to operate
properly, a water line is required.
-the maximum inlet water pressure is
689KPa;
-the minimum inlet water pressure is
207KPa.
Warning:
The water connection must be made by a
qualified plumber. Operation outside the
water pressure range may cause
malfunction, severe and damaging water
leaks.
Under normal conditions, a 200cc (5.75
oz.) cup can be filled in about 10 seconds.
If the refrigerator is installed in an area
with low water pressure (below30 psi),you
can install a booster pump to compensate
for the low pressure.
To fit the water filter, follow the installing
steps below.
1. Take out the water filter and water lines
from the fridge room.
2. Determine the location to mount the
external filter. (Note: The water filter
should be mount on the wall where it is
convenient to be replaced, and do not
mount on the wall behind the refrigerator.)
3. Determine the distance between the
Loading ...
Loading ...
Loading ...