7-outlet Power Manager with Surge
Protection and Noise Filtering
RF-HTS105
QUICK SETUP GUIDE
Congratulations on your purchase of this Rocketsh Power Manager
with surge protection and noise ltering.
Your power manager:
• Reduces energy consumption to save environmental resources
and lower your electric bill
• Provides surge protection for sensitive electronic devices
• Incorporates noise ltering to provide “clean” power that will
maximize the life-span of your devices
Features
1 Coaxial cable surge protection – protects your incoming coaxial
cable line from surges and spikes.
2 One master outlet – controls power to the four
master-controlled outlets.
3 Four master-controlled outlets – automatically shut down to
conserve energy when the device plugged into the master outlet
is turned o.
4 Two always-on outlets – provide continuous power regardless
of Master/Master-controlled outlets state.
5 Main power switch/circuit breaker – controls power to all AC
outlets on the Power Manager, and allows the unit to be reset in
the event of a circuit overload (after the overload condition has
been resolved).
6 Protected LED indicator – lights when the surge protection
feature is working properly. If this LED does not light or goes out,
the surge protection feature has reached full capacity and can no
longer absorb additional surges and spikes. The power manager
should be replaced if this light goes out.
7 Grounded LED indicator – lights when a properly grounded AC
outlet is detected. If this LED does not light, we recommend that
you contact a certied, licensed electrician to inspect your wiring.
8 5 ft (1.5 m) Soft-Flex™ power cord with right-angle/o-set
plug – enables placement of the Power Manager in the desired
location, furniture to be placed as close as possible to the wall
and will not block the second AC outlet.
• 2,100 joules surge protection – protects your equipment from
damaging power surges and spikes.
• 47 dB EMI/RFI noise ltering – ensures that your equipment
receives only clean power for maximum performance.
• Audible alarm – Sounds when the surge protection feature has
reached full capacity and can no longer absorb surges and spikes.
The power manager should be replaced if this alarm sounds.
• Power cord labels – attach these labels to your power cords
(near the plug end) to help identify which cord is attached to
which device in the event that one should need to be unplugged
for any reason. The labels are pre-printed for convenience, and
the blank labels can be customized for unique devices.
Loading ...