Loading ...
Loading ...
Loading ...
12
PUSH
TO
IGNITE
PUSH & TURN TO “HI”
Keep your face away from the grill as far as possible and pass a
lit, long stem match through the notch in the unit’s grate to the
ports of the burner you are trying to light. When attempting to
light a burner with a match, ensure that the correct burner con-
trol knob is used.
Position the match near the burner ports. Push and turn the
control knob to “HI”. Repeat procedure on each burner if necessary. If the burner does not light in 4 sec-
onds turn the knob OFF, wait 5 minutes and try again. If the burner will not light after several attempts
see page 16: Troubleshooting.
NOTE:To ensure proper spark ignition, do not change gap between the electrode wires and the burners.
The optimum gap is preset at the factory between 1/8” and 3/16.” Replace 9 VDC igniter batteries at the
first sign of spark weakness. 30” grills require one battery, all others require two. See page 6 for battery
replacement instructions.
BURNER ADJUSTMENTS:
NOTE: VERSAPOWER™ Cooking System has two burners, a center and a perimeter one. The follow-
ing instructions apply to the perimeter burners.
PERIMETER BURNER AIR ADJUSTMENT:
Each unit’s burners are tested and adjusted at the factory prior to shipment; however, variations in the
local gas supply, elevation and other factors might make it necessary to adjust the burners. The flames
of the burners should be visually checked and compared with Figure 4.
Flames should be blue and stable with no yellow tips, excessive noise or lifting.
If any of these conditions exist, check if dirt, debris, spider webs, etc., are blocking the air shutter or
burner ports. Proceed with air shutter adjustment.
CAUTION
IN SUNNY ENVIRONMENTS,
THE FLAME FROM A BURNER
MAY BE IMPOSSIBLE TO SEE.
Loading ...
Loading ...
Loading ...