Loading ...
Loading ...
Loading ...
Page 12
WARNING
Wear eye protection
during operation.
START THE MACHINE
1. Push and hold the start button.
2. While you hold the start button, pull the bail
switch in the direction of the handle bar.
3. Once the machine has started you can
release the start button.
STOP THE MACHINE
1. Release the bail switch to stop the machine.
WARNING
Wait until the blades
fully stop before you start the machine
again. Do not quickly turn the machine off
and on.
WARNING
Always remove the
battery pack after you complete the work.
OPERATE THE SELF-PROPEL
SYSTEM
NOTE
The machine is
built with a thermal protector to stop the
self-propelled motor when overload oc-
curs. It’s a device calibrated to open the
self-propelled motor circuit upon reaching
a certain temperature/current. Re-setting
the protector requires both cool down be-
low the calibration point and removal of
power supply. When the protection hap-
pens, the operator should release the self-
propel bail lever immediately ,then restart
self-propel operation after at least 30 min-
utes.
1. Start the machine.
2. While you hold the bail switch, push the
self-propel lever in the direction of the handle
bar.
3. Hold the bail switch and the self-propel
lever at the same time with your right hand.
4. Adjust the speed control button with your
left hand.
• Push the speed control button in the
direction of the Rabbit Symbol to increase the
speed.
• Pull the speed control button in the
direction of the Turtle Symbol to decrease the
speed.
5. Release the self-propel lever to close the
self-propel system.
EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Remove the battery pack.
3. Open the rear discharge door and hold it.
4. Hold the grass catcher by its handle and
OPERATION
FIG. 9
Bail Switch
Start Button
FIG. 1
0
Bail
Switch
Self-Propel
Lever
Speed
Control
Button
Loading ...
Loading ...
Loading ...