Loading ...
Loading ...
Loading ...
10
ELECTRICAL
W A R N I N G
CHECK EXTENSION CORDS BEFORE EACH USE. IF DAMAGED REPLACE IMMEDIATELY.
NEVER USE TOOL WITH A DAMAGED CORD SINCE TOUCHING THE DAMAGED AREA
COULD CAUSE ELECTRICAL SHOCK RESULTING IN SERIOUS INJURY.
ELECTRICAL CONNECTION
This tool is powered by a precision built electric motor. It should be connected to a power sup-
ply that is 120 volts, 60 Hz, AC only (normal household current). Do not operate this tool
on direct current (DC). A substantial voltage drop will cause a loss of power and the motor will
overheat. If the product does not operate when plugged into an outlet, double check the power
supply.
SPEED AND WIRING
The speed is not constant and decreases under a load or with lower voltage. For voltage, the
wiring in a shop is as important as the motor’s horsepower rating. A line intended only for lights
cannot properly carry a cultivator motor. Wire that is heavy enough for a short distance will be
too light for a greater distance. A line that can support one cultivator may not be able to support
two or three tools.
FOR ALL DOUBLE-INSULATED APPLIANCES
Replacement Parts — When servicing use only identical replacement parts.
Polarized Appliance Connections — To reduce the risk of electric shock, this appliance has a
polarized plug (one blade is wider than the other) and will require the use of a polarized exten-
sion cord. The appliance plug will t into a polarized extension cord only one way. If the plug
does not t fully into the extension cord, reverse the plug. If the plug still does not t, obtain a
correct polarized extension cord. A polarized extension cord will require the use of a polarized
wall outlet. This plug will t into the polarized wall outlet only one way. If the plug does not t fully
into the wall outlet, reverse the plug. If the plug still does not t, contact a qualied electrician to
install the proper wall outlet. Do not change the equipment plug, extension cord receptacle, or
extension cord plug in any way.
OVERLOAD PROTECTION: This cultivator is equipped with overload protection. If while using
the cultivator in heavy conditions, it suddenly shuts off, release the switch, wait 10 seconds and
re-engage. If it does not start wait 1 minute (for the motor to cool) and re-engage.
Loading ...
Loading ...
Loading ...