Loading ...
Loading ...
Loading ...
Important Safety Note: The
customer is solely responsi-
ble for proper selection of
mounting hardware not
included with the speakers,
and for proper assembly
and installation of the wall
brackets, including but not
limited to the selection of
appropriate weight-bearing
supports and proper use of
the bracket. JBL disclaims
any liability for the selection
of mounting hardware
and/or bracket installation.
Be sure to follow these
bracket assembly and
installation instructions
carefully. If you have any
questions or doubts about
your ability to correctly wall-
mount the speakers, consult
with your authorized JBL
dealer or custom installer.
Step 1: Unscrew and remove
the large
Molded Nut ™. If
necessary, use the supplied
Metal Bar ∞ as a lever by
inserting it into one of the
holes in the outer edge of
the
Molded Nut ™.
Step 2: Firmly grasp the
Ball
and Shaft £ and pull it
straight out of the
Attach-
ment Plate
¢. Avoid leaning
it to the side for leverage, as
this may break off a tab.
Step 3: Slide the
Molded Nut
™ onto the Ball and Shaft £
with the threaded opening
facing the ball. Thread the
Metal Nut ¡ all the way
onto the
Ball and Shaft £,
with the star washer side
away from the ball. Refer
to the exploded drawing for
the proper orientation of
these parts.
Step 4: Screw the
Ball and
Shaft £ into the Threaded
Insert
§ on the back of
the
Satellite Speaker ¶
until it is fully seated in the
Threaded Insert §, but do
not
tighten, as you might
dislodge the
Threaded
Insert
§. Such damage
would not be covered under
the warranty.
Step 5: Tighten the
Metal
N
ut
¡ w
ith the star washer
side between the
Nut ¡
and the back of the Satellite
Speaker
¶, using large
needle-nose pliers, until it
is firmly seated against the
back of the
Speaker ¶ and
has locked the
Ball and
Shaft £ and the Speaker
¶ together. Note that once
the Metal Nut ¡ is fully
tightened, it may embed
some marks on the back of
the
Satellite Speaker ¶.
However, these marks will
be covered by the
Metal
Nut
¡.
Step 6: Mount the Attachment
Plate
¢
into a wood stud on
the wall, using four #10 pan-
head wood screws at least
one-inch long (not supplied)
•. Make sure that all four
screws are driven into the
stud and not into drywall.
If the bracket needs to be
mounted in drywall, the
customer is responsible for
selecting and using appropri-
ate wall anchors and screws.
Important Note: The Metal
Nut
¡ must be fully tight-
ened against the
Satellite
WALL-MOUNTING
2
3
4
8
5
1
1
2
3
4
5
6
7
8
6
SCS200.5 OM 5/18/06 10:24 AM Page 6
Loading ...
Loading ...
Loading ...