Loading ...
Loading ...
Loading ...
Continued on Next Page
SB-HY-VELOSTR/10TW3 INSTR_SKU# 011355
Page 5 • JL Audio, Inc., 2013
STEP 20
Measure and mark up 4-1/2” from the floor at the center of
the indented section of the wheel wheel as shown.
STEP 24
Reference this illustration for clarity in Steps 25-29.
STEP 19
Drill a 3/8” hole on the mark made in the previous step.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a reduction
in your weekly pay.
Always wear eye protection when drilling!
STEP 23
Enlarge the hole made in the previous step to 3/8”.
STEP 18
Measure and mark down 7” from top of the factory hole as
shown.
STEP 22
Drill a 1/8” pilot hole on the mark made in Step 20.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a reduction
in your weekly pay.
Always wear eye protection when drilling!
STEP 17
Pictured is the back of the vehicle with the passenger side
panel removed.
STEP 21
Jack up the rear passenger side of the vehicle.
Loading ...
Loading ...