Loading ...
Loading ...
Loading ...
50
718585
Problem/error Cause What to do?
Laundry not dried
or drying takes too
long
• Filter is not cleaned. • Clean the filter (see chapter
»CLEANING AND MAINTENANCE/
Cleaning the net filter in the door«).
• Dryer is placed in a closed room;
room that is too cold; or room
that is too small and the air
overheats as a result.
• Make sure there is adequate
supply of fresh air to the dryer; for
example, open the door and/or
window.
• Check if the temperature in the
room where the dryer is installed is
too high or too low.
• Laundry was not sufficiently
wrung or spun.
• If the laundry is still wet after the
drying cycle, repeat the drying
and select an appropriate drying
programme (after cleaning the
filter).
• Amount of laundry dried in
the appliance is too large or
insufficient.
• Use a suitable programme or extra
functions.
• Laundry (such as bedding) gets
tangled into large balls.
• Close the buttons or zippers on
the laundry before drying. Select
a suitable programme (e.g. the
Bedding program).
• After the drying process, loosen
the laundry and select an additional
drying programme (e.g. Time
(Timed drying program).
Errors indicated on the display unit may include the following:
Problem/error Error description What to do?
E0 Control unit failure
The START DELAY signal lights (5)
flash continuously.
Call service centre.
E1 Temperature sensor failure
The START DELAY signal lights (5)
flash 1 time..
Call service centre.
E2 Communication error
The START DELAY signal lights (5)
flash 2 times.
Call service centre.
Loading ...
Loading ...
Loading ...