Loading ...
Loading ...
Loading ...
Some dispenser models offer water only. On
other models you can select CUBED ICE
or WATER .
Press the glass gently against the top of the
dispenser cradle.
If no water is dispensed when the refrigerator is
first installed, there may be air in the water line
system. Press the dispenser arm for at least two
minutes to remove trapped air from the water line
and to fill the water system. To flush out impurities
in the water line, throw away the first six glassfuls
of water.
CAUTION: Never put fingers or any other
objects into the ice crusher discharge opening.
Locking the Dispenser (on some models)
Press the Lock pad for
3 seconds to lock the
dispenser and control
panel. To unlock, press
and hold the pad again
for 3 seconds.
Dispenser Light (on some models)
This pad turns the night
light in the dispenser on
and off. The light also
comes on when the
dispenser cradle is
pressed. If this light
burns out, it should be replaced with a
6 watt maximum, 12 volt DC bulb.
8
Consumer Support
Troubleshooting Tips Installation Instructions Safety InstructionsOperating Instructions
About the dispenser.
On some models
Ice Storage Drawer
on Ice Dispenser Models
To remove:
Set the icemaker power switch to the O (off)
position. Pull the drawer straight out and
then lift past the stop position.
To replace:
When replacing the drawer, make sure to
push it firmly into place. If it does not go all
the way back, remove it and rotate the drive
mechanism 1/4 turn. Then push the
drawer back again.
Important Facts About Your Ice Dispenser
■ Do not add ice from trays or bags to
the storage bin. It may not crush or
dispense well.
■ Avoid overfilling glass with ice and use
of narrow glasses. Backed-up ice can jam
the chute or cause the door in the chute
to freeze shut. If ice is blocking the
chute, poke it through with a wooden
spoon.
■ Beverages and foods should not be
quick-chilled in the ice storage bin.
Cans, bottles or food packages in the
storage bin may cause the icemaker
or auger to jam.
■ To keep dispensed ice from missing
the glass, put the glass close to, but
not touching, the dispenser opening.
■ The first glass of water dispensed may be
warmer than the following ones. This is
normal.
■ Dispensed water is not ice cold.
For colder water, simply add ice cubes
before dispensing water.
To Use the Dispenser
Drive
Mechanism
Rotate
Loading ...
Loading ...
Loading ...