Loading ...
Loading ...
Loading ...
Inca HC Electronic Control 03/15 - Page 7
INSTALL THE Range hood
1. Remove the range hood from the carton and place
on a at surface. Cover the surface to prevent accidental
damage. Remove all parts including the backdraft damper,
plastic grille and literature package before discarding the
carton.
2. Remove the grease lters from the range hood and set
aside. The grease lters are removed by pressing the handle
of the lter as indicated in FIGURE 6. When replacing, make
sure that the lters are properly positioned with the handles
in front and visible.
MAKE YOUR CUT-OUTS
1. Disconnect and move freestanding range from cabinet
opening to provide easier access to upper cabinet and rear
wall. Put a thick, protective covering over cooktop, set-in
range or countertop to protect from damage or dirt.
2. Determine and clearly mark with a pencil the center
line on the cabinet where the range hood will be installed.
3. Determine and make all necessary cuts in the wall for
the ductwork. Install the ductwork before the range hood.
4. Determine the proper location for the Power Supply
Cable. Use a 1 1/4" Drill Bit to make this hole. Install the
cable. Use caulking to seal around the hole. DO NOT turn
on the power until installation is complete.
5. Make the cut-out opening where the range hood will be
installed (FIGURE 5).
FIGURE 5
CUT-OUT
27 5/8"
13 5/32"
FIGURE 6
3. Place the round damper into the exhaust opening of
the range hood and press down.
4. The range hood mounts to the cabinet by two spring
loaded brackets, one on each side of the range hood. Lift
the range hood into the cutout opening in the cabinet. Be
careful not to damage the cabinet, range hood or other ap-
pliances.
5. Tighten the range hood to the cabinet by rotating the
screws indicated in FIGURE 7 with a phillips screw driver.
FIGURE 7
6. Remove the metal knockout hole on the back or top of the
right side of the hood with a at head screwdriver. Feed the
Power Supply Cable through the electrical knockout.
Remove the cover from the eld wiring compartment with a
phillips screwdriver. Connect the Power Supply Cable to
the range hood cable. Attach the White lead of the power
supply to the White lead of the range hood with a twist-on type
wire connector. Attach the Black lead of the power supply
to the Black lead of the range hood with a twist-on type wire
connector. Attach the Power Supply Cable grounding lead
to the green screw provided. Replace the cover.
7. Replace the grease lters.
8. Connect the ductwork to the damper and seal all con-
nections with duct tape.
9. Turn the power supply on. Turn on the blower and
light. If the range hood does not operate, check that the
circuit breaker is not tripped or the house fuse blown. If the
unit still does not operate, disconnect the power supply and
check that the wiring connections have been made properly.
Loading ...
Loading ...
Loading ...