Loading ...
Loading ...
Loading ...
16
WATER INLET BASIN
• The water inlet basin includes the water
reservoir in the base of the unit that also houses
the transducer and the heating element.
• Clean the water basin with a soft cloth. If there
is excess film or calcification on the surface,
then soak the cloth with the vinegar and water
solution and repeat the process.
• If there is film or calcification in any of the
depressions along the basin, drop a bit of
vinegar and water solution into the depression
and lightly clean it with a brush or a cotton
swab.
• Rinse with clean or distilled water and allow
to dry.
OPTIONAL CLEANING SOLUTION FOR
CALCIFICATION ISSUES
• If a build-up of calcification on the transducer
or heating element occurs and cannot be
removed with a simple vinegar and water
solution, use a de-calcifying agent or citric acid.
STRICTLY FOLLOW THE INSTRUCTIONS ON
THE PACKAGING FOR THESE CLEANING
PRODUCTS.
• Brush off any scale deposits from the transducer
and heating element surfaces using the brush or
a cotton swab.
• Rinse with clean or distilled water and allow to
dry.
WARNING
Never use sharp or solid objects to clean the
transducer and heating element. Avoid touching
the transducer and heating element with your
fingers.
NOTE
The heating element in the base of the humidifier
will lose its stainless steel finish over time - this
is normal. It is still recommended to de-calcify
as per instructions noting that cleaning may not
bring it back to its original shine.
WATER PURIFICATION FILTER
It is recommended that you clean the water
purification filter every time you clean the
humidifier, especially if in frequent use.
If the filter is cleaned regularly and as per
instructions, it should last for the life of the
humidifier.
• Remove the cover from the top of the humidifier
and set aside.
• Using the handle, remove the water tank from
the humidifier.
• Turn the water tank gently upside down and
remove the water tank cap.
• The water purification filter is connected to the
water tank cap. Unscrew the filter from the cap
to clean.
• Dip the filter cartridge in a vinegar and water
solution for about 10 minutes before thoroughly
rinsing with clean water. Alternatively, rinse the
filter under running tap water for a minute.
• Once clean, place the filter in direct sunlight
and allow to dry for at least an hour.
• Reconnect the filter to the water tank cap,
then screw the cap onto the water tank.
• Turn the water tank the right-side up and
place the tank onto the base carefully.
• Place the nozzle and top cover on top of the
water tank.
LAH400_ANZ_IB_A19.indd 16 27/2/19 8:50 am
Loading ...
Loading ...
Loading ...