Loading ...
Loading ...
Loading ...
2) Fix the angle bars to the hanging plate,
using the 8 x M4 nuts and bolts with metal
washers.
3) Extend the angle bars to the required height
and then fix them in position using the 16 x M4
nuts and bolts with metal washers.
o IMPORTANT: The angle bars must have an
overlap of AT LEAST 100 mm.
4) If your cooker hood is going to be used in
extraction mode, then you should connect the
ducting hose to the ceiling adaptor at this point.
o Fix the upper chimney section to the
hanging plate, using the 4 x self tapping
screws.
o Slide the lower chimney section onto the
angle bars and raise it until it sits just below
the upper chimney section.
o Use the hanging hook to temporarily keep the lower chimney
section in this position, to make sure that it does not drop down
whilst fixing the main body of the hood to the angle bars.
20
Loading ...
Loading ...
Loading ...