Loading ...
Loading ...
Loading ...
10
Note: If required you may lay the refrigerator on
its back in order to gain access to the base, you
should rest it on soft foam packaging or similar
material to avoid damaging the backboard of the
refrigerator. To reverse the door, the following
steps are generally recommended.
1. Stand the refrigerator upright. Open
the upper door to take out all door racks and
tank (to avoid damage) and then close the door.
2. Use a putty knife or thin-blade screwdriver to
prize the screw hole cover which is at the top left
corner of the refrigerator, and the upper hinge
cover which is at the top right corner of the
refrigerator.
3. Unscrew the special flange self-tapping screws
which are used for fixing the right upper hinge
part by a 8mm socket driver or a spanner (please
support the upper door with your hand when
doing it) .
4. Remove the upper hinge axis, transfer it to
reversed side and tighten securely, then put it in a
safe place.
5. Remove the upper door from the middle hinge
by carefully lifting the door straight up.
NOTE: When removing the door, watch for
washer(s) between the center hinge and the
bottom of the freezer door that may stick to the
door. Do not lose.
6. Place the upper door on a smooth surface with
its panel upwards. Loose screw ② and part ①,
then Install them to the left side and tighten
securely.
7. Unscrew the two special flange self- tapping
screws which are used for fixing the middle hinge
part, then remove the middle hinge part that
hold the lower door in place.
NOTE: When removing the door, watch for
washer(s) between the center hinge and the
Water tank
Door racks
Screw hole
cover
Upper hinge
cover (right)
special flange
selftapping screws
right upper hinge part
① Stop block
② Self-tapping screw
Loading ...
Loading ...
Loading ...