Loading ...
Loading ...
Loading ...
68 TROUBLESHOOTING
Oven light does not
work.
It is time to replace the lamp or the lamp is not tightened enough.
Replace or tighten lamp. See "Changing the Oven Light" section in this Owners Manual.
The plug on the range is not completely inserted in the electrical outlet.
Make sure the electrical plug is inserted into a live, properly grounded outlet.
Oven will not Self
Clean. (On some
models)
The oven temperature is too high to set a Self Clean operation.
Allow the range to cool and reset the controls.
Oven controls improperly set.
See the Self Clean section.
A Self Clean cycle cannot be started if the oven Control Lock feature is active.
See the "Control Lock" in "Changing Oven Settings" section.
Oven door does not
open after a Self
Clean cycle (On some
models)
Oven is too hot.
Allow the oven to cool below locking temperature.
The control and door may be locked.
Allow about one hour for the oven to cool after the completion of a Self Clean cycle. The
door can be opened when the lock
k is no longer displayed.
The oven is not clean
after a Self Clean
cycle (On some
models)
Oven controls not properly set.
See the Self Clean section.
Oven was heavily soiled.
Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to
Self Clean again or for a longer period of time.
CLEAN and door
flash in the display
(On some models)
The Self Clean cycle has been selected, but the door is not closed.
Close the oven door.
"Loc" is on in the
display when you
want to cook (On
some models)
The oven is locked because of the Control Lock feature.
Deactivate the Control Lock feature.
Oven control beeps
and displays any F
code error.
Electronic control has detected a fault condition.
Remove the power from the range for five minutes and then reconnect the power. If the
function error code repeats, call for service.
Check the main gas shut-off valve or the oven gas shut-off valve and call for service.
The oven racks were
cleaned in a Self
Clean cycle. (On
some models)
The shiny, silver-colored racks were cleaned in a Self Clean cycle.
Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven
racks with the paper towel. Do not use lubricant sprays.
Displayed colon in
the clock is flashing
This means that the product has just been plugged in, or that it has experienced a
power interruption.
This is normal. Reset the clock and any cooking function.
Light can be seen
through the oven air
vents.
While the Broil function is running, it is normal to see a light between the oven air
vents.
This is normal.
Problem Possible Cause & Solution
Loading ...
Loading ...
Loading ...