Loading ...
Loading ...
Loading ...
5
1
Keep adequate ventilation space around the
refrigerator.
The gure shows the
minimum required
space for installing
the refrigerator. The
amount of space around
the refrigerator a󰀨ects
the amount of power
consumption.
Insu󰀩cient spacing
will decrease cooling
e󰀩ciency and increase energy consumption. This
may reduce the life of the unit and void warranty.
If using the refrigerator in the smaller space
dimension than gured, it may cause temperature
rise in the unit, loud noise and failure.
The space between the rear of the refrigerator and
the wall should be 60mm or more, and less than
75mm.
If the space is wider than 75mm, you may get
injured by touching the compressor and its
peripheral parts which are extremely hot during the
operation.
Overall space required in use
Installation
Free standing type
90mm
or more
60mm
or more
60mm
or more
1180 mm
1500 mm
2
Use the two front adjustable feet to place the
refrigerator atly and rmly on the oor.
3
When right and left doors are not properly aligned,
adjust using the adjustable feet.
Adjustable foot
Note
Position your refrigerator so that the plug is accessible.
Keep your refrigerator out of direct sunlight and do not
place next to heat generating appliance.
Do not place your refrigerator directly on the ground.
Insert suitable stand such as wooden board under the
refrigerator.
When you insert the power plug with the door opened,
door alarm sounds but it is not abnormal. This sound
stops after closing the door.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm
water.
If soapy water is used, wipe it o󰀨 thoroughly with water.
When the left door is
raised.
When the right door is
raised.
Lower the foot
at right side.
Lower the foot
at left side.
(Until the adjustable foot on the
other side is slightly o󰀨-ground.)
4
Remove the 4 screws of the lower part of the cabinet
and use these screws to set the foot cover. (The foot
cover is packed inside the refrigerator compartment.)
Screw
(4 screws)
Screw
Foot cover
5
Connect the power plug to a 230/240 volt. 10 amp.
power point.
(B979).indb 5(B979).indb 5 2020/04/06 17:33:562020/04/06 17:33:56
Loading ...
Loading ...
Loading ...