Loading ...
Loading ...
Loading ...
4
4. Using two Phillips-head screws, attach each back panel to the
panel above.
NOTE: Using three Phillips-head screws, attach the last back
panel (P8) to the cabinet bottom (P3).
5. Completely tighten all back panel screws starting with the sides
and continuing with the top, middle and bottom.
6. Using the hex key (provided), completely tighten all 24 cabinet
bolts and nuts.
Install Leveling Legs
1. Place the cabinet on its side.
2. Screw a leveling leg (P4) into each of the four rivet nuts located at
the corners of the cabinet as shown.
3. Stand the cabinet upright.
4. If you have not already done so, fasten the two bolts at each
front corner, of the cabinet frame. Completely tighten all the
cabinet bolts and nuts.
Install Shelves
IMPORTANT: Use the pair of holes located in the middle of the
cabinet sides to install a center shelf without the magnet (P5), so the
doors will lock. The other two shelves with magnet (P5m) may be
installed where desired.
1. Place a shelf (P5) so that the holes in the ends are aligned with
the pair of holes in the middle of the cabinet sides.
NOTE: Make sure the holes in the long edge of the shelf are
facing out.
2. Using two screws and nuts per side, fasten the shelf (P5) to the
sides (P1).
3. Determine where you want to place the other two shelves (P5m).
Align the holes in the shelf ends with the holes in the cabinet
side.
NOTE: Make sure the magnets on the long edge of the shelf are
facing the cabinet front.
4. Using two screws and nuts per side, fasten the shelves (P5m) to
the cabinet sides (P1). Completely tighten the nuts.
A. Cabinet bottom
A. Leveling legs
P1
P3
A
P1
P8
P8
P8
P8
P8
P8
P3
P1
P4
P8
P8
P8
A
F3c F5
F3c
F5
Phillips-head screw (12)
Small flange nut (12)
A. Middle pair of holes in cabinet side
A
P1
P2
P1
P3
P5
P8
P8
P8
P8
Loading ...
Loading ...
Loading ...