Loading ...
Loading ...
Loading ...
10
Warning: If there is any break in the power supply while
the machine is operating, a special memory stores the
selected programme and, when the power is restored, it
continues where it left off.
“CHILD LOCK” button
G
This is a useful feature to prevent children playing with the option buttons and tampering with
the programme you have set.
After you have set the programme and option buttons you require. Press START button and
then hold down Child lock button for few seconds until the symbol " " will appear
on the display. This "locks" the control panel.
You may cancel this funtion by pressing the Child lock button for few seconds until the
symbol " " will disappear.
“PRE-WASH” button
This option is particularly useful for heavily soiled loads and can be used only on some
programmes as shown in the programmes table.
Detergent for this programme should be added to the compartment of the soap drawer
labelled “1” (Please refer to Detergent Drawer Section of manual). We recommend you use
only 20% of the recommended quantities shown on the detergent pack and fabric
conditioner should not be used for this programme.
H
I
STAIN BLASTER Button
By pressing this button, which can only be activated in the Cotton cycles, the sensors in the
new system come into operation. They affect both the selected temperature, keeping it at a
constant level throughout the wash cycle, and the mechanical function of the drum.
The drum is made to turn at two different speeds at crucial moments. When the detergent
enters the garments, the drum rotates in such a way that the detergent is distributed in a
uniform manner; during the wash and rinse procedures, however, the speed increases in
order to maximise the cleaning action. Thanks to this special system, the efficiency of the
wash procedure is improved WITHOUT ANY INCREASE IN THE LENGTH OF THE
PROGRAM.
RINSE HOLD Button
Pressing this button means
the cycle stops at the final
rinse stage, leaving the drum
filled with water.
The garments thus stay
immersed in the water,
preventing them from
bunching up and forming
creases that are difficult to
remove.
During the phase in which
the water is held in the tub,
the indicator blinks to show
that the machine is at a
standstill. Release the button
to end the cycle with a spin
(which may be reduced or
cancelled using the
appropriate button) and
emptying
L
phase.
Loading ...
Loading ...
Loading ...