Loading ...
Loading ...
Loading ...
ENGLISH
14
Accessories
WARNING: Since accessories, other than those
offered by
DeWALT
, have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only
DeWALT
recommended accessories should be used with
thisproduct.
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact
DeWALT
Industrial
Tool Co., 701East Joppa Road, Towson, MD 21286, call
1-800-4-
DeWALT
(1-800-433-9258) or visit our website:
www.dewalt.com.
Replacing the Return Springs and Profile
WARNING: For your own safety, read the tool
instruction manual before using any accessory.
Failure to heed these warnings may result in serious
personal injury and damage to the tool and the
accessory. When servicing this tool, use only identical
replacementparts.
CAUTION: If you don't feel comfortable servicing your
tool, take it to a
DeWALT
authorized service center.
The user should only attempt to service the springs
and profile. All other service should be completed by
an authorized
DeWALT
service center.
CAUTION: Do not lubricate any of the replacement
parts. Lubrication can damage the parts and seriously
affect the life and performance of thetool.
NOTICE: All the mechanical parts of the spring
replacement kit are shown for convenience and
verification of inclusion. The kit also contains a packet
of Loctite adhesive for use in Step9. Refer to Fig.S.
DCN6901 Return Spring Replacement
Kit (Fig. N–S)
To Change Broken or Worn Return Springs
NOTE: Springs should be replaced as a pair, using only the
correct
DeWALT
accessory spring replacementkit.
1. Using the key
11
provided, loosen the two screws
19
on either side of the unit. Refer to FigureN.
2. Remove the return system
20
from the unit. Refer to
FigureO.
Fig. N
19
11
Fig. O
20
3. Slide the spring rail clip
21
off of the spring rail
22
.
Refer to FigureP.
4. Twist and remove the spring bumper
23
and remove
the washer
24
and return spring
17
. Refer to FigureQ.
Fig. P
21
22
23
Fig. Q
21
23
24
17
5. Mount the new return spring and washer on to the
spring rail
22
. While compressing the spring with the
washer near the opposite end of the rail, twist on the
new spring bumper until it is past the groove for the
spring railclip.
Loading ...
Loading ...
Loading ...