Loading ...
Loading ...
Loading ...
- 7
Check the flat folded filter, clean if re-
quired
Check moving parts for freedom of
movement.
Check the sealing strips in the sweep-
ing area for wear.
Half-yearly maintenance:
Check tension, wear and tear and func-
tioning of the drive belts.
Maintenance following wear:
Replace sealing strips.
Replace roller brush.
Replace side brush.
For description, see section on Mainte-
nance work.
Note
Where maintenance is carried out by the
customer, all service and maintenance
work must be undertaken by a qualified
specialist. If required, a specialised Archer
dealer may be contacted at any time.
Park the sweeper on an even surface.
Turn the program selection switch to
"OFF".
Loosen 3 fastening screws.
Replace side brushes and tighten the
screws.
It is necessary to replace them if the sweep
results are visibly poorer due to wear and
tear of the brushes and it is not possible to
readjust them using "Lever contact pres-
sure of sweep roller".
Remove the waste container.
Figure 8, see cover page
Pull the lever for contact pressure of
sweep roller fully backwards.
Loosen 3 screws each on both the
sides of the sweep roller.
Separate the roller halves and remove
them.
Place new roller halfs on the sweep roll-
er shaft. Ensure that the pins are sitting
correctly.
Fix in the screws and tighten them.
Loosen the screws as shown in the re-
spective diagram.
Remove the sealing strip and replace it
with a new sealing strip.
Fix in the screws and tighten them.
Front sealing strip (at the waste contain-
er)
Figure 9, see cover page
Rear sealing strip
Figure 10, see cover page
Side sealing strips
Figure 11, see cover page
Pull the handle of the filter shake-off
many times and release it.
Tilt the dust suction upward.
Figure 12, see cover page
Lift out the flat-fold filter and insert a
new flat-fold filter.
Remove both the foam filters.
Clean the foam filters under flowing wa-
ter and let them dry.
Push in the foam filters into the casing.
Ensure that the foam filters are gap-free
on all sides.
In the U.S. or Canada, please call
1-800-537-4129 for warranty issues and
visit www.karcher-help.com for technical
support and product assistance.
Please take a moment to register your
pressure washer online at
www.karcher-register.com. Be sure to
save your purchase receipt, it will be re-
quired for repairs covered by warranty.
Call: 01-800-024-13-13 for help or visit our
website: www.karcher.com.mx
Maintenance Works
Replacing side brush
Replacing roller brush
Replace the sealing strips
Replace flat fold filter (only Adv. model).
Cleaning the flat-fold filter
Customer Support
USA and Canada
Customer Support Mexico
9EN
Loading ...
Loading ...
Loading ...