Loading ...
Loading ...
Loading ...
18
2. Get access to the set-up mode of TIME/DISTANCE/CALORIES/PULSE.
When you are in each set-up mode, for example in the time set-up mode: time value is blinking,
you can press "SET" button to adjust the value and press "MODE" for confirmation. The set-up of
DISTANCE, CALORIES & PULSE is the same as TIME.
3. With any signal been transmitted into the monitor, the value of TIME, DISTANCE, CALORIES start
to count up as Drawing C. When there is any function has been pre-set the target (TIME or
DISTANCE or CALORIES), the function will be counting down from the pre-set to zero while the
training starts.
Once the target is achieved to zero, the monitor start to beep for 8 seconds, and the function will
be counting up from zero directly if the training is going. Press "MODE" button for confirmation
and skip to next set-up.
Drawing A Drawing B
Drawing C
4. In SCAN mode shown as "Drawing C". RPM/
SPEED/TM/DIST/CAL/PULSE will skip to
display in every 6 seconds. The order is as
follows.
5. You can also press "MODE" button to select
single function display except RPM & SPEED
function. The RPM & SPEED function will
switch display.
| COMPUTER OPERATION
Loading ...
Loading ...
Loading ...