Loading ...
Loading ...
Loading ...
en Cleaning
30
D Cleaning
Cleaning
Cleaning the dryer and the
control panel
:Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
Disconnect the dryer from the mains
before cleaning.
Clean the dryer using only water and a
soft, damp cloth.
Remove all detergent residue, spray
residue or other residues immediately.
Do not use cleaning agents or agents
for pre-treating laundry (e.g. prewash
sprays, stain removers). Do not use
high-pressure cleaners or steam jet
cleaners to clean your appliance.
Cleaning the heat exchanger
Notes
■ The heat exchanger requires
cleaning once a month, however this
varies depending on how frequently
the dryer is used.
■ If there is debris in the heat
exchanger, this will increase the
amount of time required for drying
and will compromise the drying
results.
1. Allow the dryer to cool down and
place an absorbent cloth beneath
the maintenance flap.
Note: Residual water may leak out.
2. Open the maintenance flap fully.
3. Turn both locking levers towards
each other.
4. Remove the top cap from the heat
exchanger.
5. Remove the heat exchanger.
6. Flush water through the heat
exchanger from all sides to
completely remove all fluff.
Caution!
There is a risk of damage to the heat
exchanger.
Only use water to clean the heat
exchanger, and do not use any hard
objects or objects with sharp edges
to remove the fluff.
7. Remove all fluff from the seals on
the dryer and on the heat exchanger.
8. Allow all the water to drip off.
Loading ...
Loading ...
Loading ...