Loading ...
Loading ...
Loading ...
24
en Blender
5. Place the juice centrifuge in the bowl.
6. Attach the lid of the juice centrifuge with
the pusher. Observe the marking (.)
when doing so.
7. Rotate the lid clockwise as far as
possible.
8. Insert the mains plug. Set the rotary
switch to the setting min.
Add fruit or vegetables to the filling
shaft and push down with the
pusher, applying light pressure. Cut
up beforehand if necessary. After
processing, briefly set the rotary switch
to the setting max and let the appliance
run until the pulp is fully squeezed out.
After processing, set the rotary switch to
P. Disconnect the mains plug.
Clean all parts immediately after use.
X “Cleaning and maintenance” see
page 26
Caution!
Empty the bowl in good time:
– after processing max. 500 g,
– before the juice reaches the grating
container.
Blender
For mixing liquid or semi-solid food,
for cutting / chopping raw fruit and
vegetables and for puréeing food.
Blender jug made of Tritan
Tritan is an unbreakable plastic with no
discernable taste or smell. Blender jugs
made of Tritan can be used to process ice
cubes and frozen food.
W Risk of injury
Never reach into the attached blender! Do
not remove / attach the blender until the
drive is at a standstill. Do not touch the
blades of the blade insert with bare hands.
W Risk of scalding!
When processing hot liquids, steam
escapes through the funnel in the lid. Add
a maximum of 0.4 litres of hot or frothing
liquid.
Caution!
Do not expose the blender jug to
temperatures above 80°C.
X Fig. I
1. Attach the blender. Observe the
marking (.) when doing so. Rotate the
blender clockwise as far as possible.
2. Add ingredients.
Processing quantities
Solid food For optimum
results 80 g
Liquids max. 1.5 l
Hot or frothing liquids max. 0.4 l
3. Attach the lid and rotate clockwise. The
lid lug must be fully inserted in the slot
of the blender handle.
Caution!
– Do not operate the blender when empty.
– The blender will not operate until the lid
is screwed on tight.
4. Insert the mains plug. Set the rotary
switch to the desired setting.
Adding more ingredients
5. To add more ingredients, set the rotary
switch to P. Remove the lid and add
ingredients, or
6. remove the funnel and gradually add
solid ingredients through the filling
opening.
7. Pour liquid ingredients through the
funnel.
After processing, set the rotary switch to
P. Disconnect the mains plug.
Clean all parts immediately after use.
X “Cleaning and maintenance” see
page 26
Tip: To preclean, pour a little water with
detergent into the attached blender. Switch
to setting M for several seconds. Discard
the water and rinse the blender with clean
water.
Loading ...
Loading ...
Loading ...