Loading ...
Loading ...
Loading ...
Installation manual
Reverse Door
Do not cover racks with aluminum foil or any other mate- rial that will prevent adequate
air circulation within the cabinet.
1. Lower hinge (Right) 2. crews for door axis 3. Door axis
4. Door . crews for actuator . Door switch press plate
. Upper hinge(Right) 8. crews for hinge 9.Decorative screws
10. Upper hinge(Left) 11. Lower hinge(Left)
12. crews for door stopper 13. Door stopper
14. crew holes for door limit device 1. crew holes for Actuator
1. Open the door④ to a 90 degrees angle, remove the screws for door axis② and
remove the door according to the direction of arrow. (Ref Fig A, B)
2. Loosing the screws for actuator⑤ and the screws for door stopper⑫. Remove Door
switch press plate⑥ and door stopper⑬, then install these two parts on the door’s
upper side.(Ref Fig A, B, ⑭ and ⑮)
3. Loosing the decorative screws⑨ and screws⑧ for right upper hinge⑦. Install upper
hinge(Left) with screws⑧, and use decorative screws⑨ to cover the three holes on
product’s upper right corner.(Ref Fig C, D)
4. To rotate the door④ 180 degrees, put the door axis on the bottom of door stopper and
hold by hand. Install them on the product’s left, between upper hinge(left) and lower
hinge(left). Use screws for door axis to lock the door and door axis will finally finish
the steps of change door opening direction.
7
Loading ...
Loading ...
Loading ...