Loading ...
Loading ...
Loading ...
11
To enable the setting, select "DISABLE PAPER
SIZE SET" and press the [OK] key so that a
checkmark appears in the checkbox.
To disable the setting, select "DISABLE PAPER
SIZE SET" once again and press the [OK] key so
that the checkmark is cleared from the checkbox.
ENERGY SAVE
These programs are used to configure energy saving
settings. To access one of these programs, select
"ENERGY SAVE" in the mode selection screen, and
select the desired program in the energy save screen,
and then press the [OK] key.
AUTO POWER SHUT-OFF
This program is used to enable auto power shut-off
mode, which automatically turns off the power to the
fusing unit if the operation panel is not used for a
certain duration of time.
Enabling auto power shut-off mode helps conserve
energy, preserve natural resources, and reduce
environmental pollution.
The function is initially enabled.
To enable auto power shut-off mode, select "AUTO
POWER SHUT-OFF", and press the [OK] key so
that a checkmark appears in the checkbox.
To disable auto power shut-off mode, select
"AUTO POWER SHUT-OFF" once again and press
the [OK] key so that the checkmark is cleared from
the checkbox.
AUTO POWER SHUT-OFF TIMER
This program is used to set the duration of time until
auto power shut-off mode activates when the
operation panel is not used. Using this function helps
conserve energy, preserve natural resources, and
reduce environmental pollution.
"5 min.", "30 min.", "60 min.", "120 min." or "240 min."
can be selected for the duration of time. Select a
setting that suits your work conditions.
The factory default setting is "5 min.".
Select "AUTO POWER SHUT-OFF TIMER" and press
the [OK] key. The following screen will appear.
1
Select the desired time with the [ ] or [ ]
key.
2
Press the [OK] key.
PREHEAT MODE
This program is used to set the duration of time until
preheat mode, which automatically lowers the fusing
unit temperature, activates when the operation panel is
not used. Using this function helps conserve energy,
preserve natural resources, and reduce environmental
pollution. "1 min.", "5 min.", "30 min.", "60 min.", "120
min.", or "240 min." can be selected for the duration of
time. Select a setting that suits your work conditions.
The factory default setting is "1 min.".
Select "PREHEAT MODE" and press the [OK] key.
The following screen will appear.
1
Select the desired time with the [ ] or [ ]
key.
2
Press the [OK] key.
TONER SAVE MODE
The toner save mode will reduce toner consumption by
approximately 10% in the automatic and text,
exposure modes. Copies will be lighter but still
adequate for general use. Selection of this mode has
no effect on the photo mode.
The function is initially disabled (factory default
setting).
To turn on the toner save mode, highlight "TONER
SAVE MODE" and press the [OK] key to display a
check mark in the check box.
To turn off the toner save mode, select this
program and press the [OK] key again to clear the
check mark in the check box.
Rather than disabling the auto power
shut-off feature, it is recommended that you
first try lengthening the time set in "AUTO
POWER SHUT-OFF TIMER" (see below).
In most cases a suitable timer setting will
allow work to proceed with minimal delay
and still enable you to enjoy the benefits of
power conservation.
Note
AUTO POWER OFF
5 min.
(5~240)
PREHEAT MODE
1 min.
(1~240)
Pegasus‑EKeyopeSec.book11ページ２００６年２月１５日 水曜日 午後２時３５分
Loading ...
Loading ...
Loading ...