Loading ...
Loading ...
Loading ...
10
Bowl, white flat beater and white
spiral dough hook may be washed in
an automatic dishwasher. Or, clean
them thoroughly in hot sudsy water
and rinse completely before drying.
Wire whip, burnished spiral dough
hook and burnished flat beater
should be hand washed and dried
immediately. Do not wash wire whip,
burnished spiral dough hook and
burnished flat beater in a dishwasher.
Do not store beaters on shaft.
Care and Cleaning
1. Unplug Stand Mixer.
2. Place bowl lift handle in down
position.
3. Attach flat beater.
4. Adjust so flat beater just clears
bottom surface of bowl when in
lifted position by turning screw (A)
clockwise to raise the bowl and
counterclockwise to lower the
bowl. Just a slight turn is all that is
required: the screw will not rotate
more than
1
⁄4 turn (90 degrees) in
either direction. (The full range of
adjustment is
1
⁄
2 turn, or 180
degrees.)
5. Place bowl lift handle in up
position to check clearance.
6. Repeat steps 4 and 5 if necessary.
NOTE: When properly adjusted, the
flat beater will not strike on the
bottom or side of the bowl. If the flat
beater or the wire whip is so close
that it strikes the bottom of the
bowl, coating may wear off the
beater or wires on whip may wear.
Beater to Bowl Clearance
Your Stand Mixer is adjusted at the factory so the flat beater just clears the
bottom of the bowl. If, for any reason, the flat beater hits the bottom of the
bowl or is too far away from the bowl, you can correct the clearance easily.
NOTE: Always be sure to unplug
Stand Mixer before cleaning. Wipe
Stand Mixer with a soft, damp cloth.
Do not use household/commercial
cleaners. Do not immerse in water.
Wipe off beater shaft frequently,
removing any residue that may
accumulate.
A
Loading ...
Loading ...
Loading ...