Loading ...
Loading ...
Loading ...
9
Tighten both screws (Inbus 5 mm) again. Attach the
cover cap again.
Notes
‒ The alignment of the appliance door can be
adjusted via the upper hinge, in order to achieve a
precise gap size of the top edge of the door to the
upper air output.
‒ The height of the door cannot be adjusted.
‒ The device door is already aligned when the
appliance is delivered. You do not normally need to
align the door.
Three wire connection
BO 450/451-610
1 Connect red wire from oven to red electrical supply
wire (hot wire).
2 Connect black wire from oven to black electrical
supply wire (hot wire).
3 Connect yellow/green ground oven wire to bare
ground electrical supply wire.
Attach flexible conduit to the junction box.
To facilitate serviceability, the flex conduit must not be
shortened and should be routed to allow for temporary
removal of the oven.
Combination with warming drawer,
width 30" (76 cm)
Installation BO/BS (width 30" (76 cm)) over warming
drawer WS only with dimensionally stable partition floor.
Check the Installation
9 WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
Switch on the circuit breaker.
Verify that elements function properly.
Removal
1 Disconnect the appliance from the power supply.
2 Undo the fastening screws.
3 Raise the appliance slightly and pull it out
completely.
Loading ...
Loading ...
Loading ...