1. Home
  2. Waring Commercial
  3. Waring Commercial CB15V User Manual
  4. Page 4

User Manual - Page 4

For CB15V.

Loading ...
Loading ...
Loading ...
6
7
4. Press the green POWER
button to turn on the
blender.GreenLEDwill
illuminate and remain steady.
Select the desired speed
with the variable speed
controlknob.Pressthered
START/STOP
buttontobeginblending.Youmay
change the speed with the variable speed control knob
anytime during blending. When nished blending, press
START/STOP
button.Formomentaryoperation,press
thegreyPULSE
button; motor will run on HIGH speed
untilthebuttonisreleased.TheGreenLEDwillblink
during operation.
5. Always hold container with one hand when starting
andwhileblending.Neveroperatewithoutcontainerlid
properly clamped in place.
6. Allow motor to come to a complete stop before
removingcontainer.Neverplacethecontaineronthe
motor base or remove it from the motor base while the
motor is running.
7.PressthePOWER
button again to turn off the blender.
8. Remove the container from the motor base and empty
the contents.
9. Wash and dry container after each use. See separate
Cleaning & Sanitizing Instructions for All Waring
Blenders.
10. Not for Waterjet Cleaning.
11. The use of ear protection is recommended during
extended operating periods.
TO REALIZE MAXIMUM SERVICE LIFE, OBSERVE THE
FOLLOWING PRECAUTIONS:
1. Do not lubricate container bearing, drive shaft, or shaft
seals. These parts are lubricated and sealed at the
factory and do not require any further lubrication.
2. Reduce amounts of material processed to less than the
full4-litercapacitywhenworkingwithviscousorbrous
materials.
3. When cleaning exterior of container, keep it in normal
upright operating position to prevent liquids from running
into the bearing through the bottom end.
HOT BLENDING INSTRUCTIONS: IMPORTANT!
To minimize the possibility of scalding when blending hot
materials, the following precautions and procedures must be
observed:
•Hotmaterialsarethosewhichare100˚F(38˚C)orhotter.
•Alwaysstartblendingonlowestspeedsetting,then
progress to desired speed.
•Neverstanddirectlyoverblenderwhenitisbeingstarted
or while it is running.
•Constantmonitoringoftheconditionofthecontainerlid
gasket and the container lid clamps is mandatory. Replace
these parts if they become worn or loose, or are damaged
in any way.
MAINTENANCE
Motor-NotforWaterjetCleaning.
The Waring Commercial Blender ball bearing motor requires
nogreasingoroiling.Sealed-inlubricationprovidessmooth
unit operation.
Container-Thestainlesssteelcontainercanbesterilized
without injury to the bearing.
Container pad to be washed and rinsed in solutions noted in
Cleaning and Sanitizing Instructions.
Depending on the operating conditions, service life of the
main components of the container blade assembly, socket
head shaft and shaft seals is 500 hours actual running time.
Loading ...
Loading ...
Loading ...