Loading ...
Loading ...
Loading ...
The lint filter must be used during washing.
It must be cleaned in time after each using.
1.Push down the spring piece of the top lint
filter to make the claws out of the filter
cover, and then pull out the lint filter to get
it down.(figure 1).
2.Pull the back of the lint filter, and then you
can get down it off the front cover of the
lint filter.(figure 2).
3.Sweep the lint in the lint filter.
4.Put the back of the lint filter into the front
cover.
5.Put the lint filter into filter cover, and make
it tight.
6.Make sure the lint filter well installed, or it
can influence your use.
Down
Install
Dismantle
Down
Up
Up
The front cover of the lint filter
The back cover of the lint filter
Dismantle
Install
The mehods of dismantle and install lint filter
as follows:
Remove the power plug before carrying out any cleaning or maintenance.
Clean the lint filter(s) and detergent box after each wash,otherwise it may influence
you using the machine.
Cleaning or Maintenance
The filter at the water inlet valve may
become blocked by impurities in the
water supply.Clean it with a plastic
bristled brush every two months.
If the cabinet is dirty,wipe it with a damp cloth
Do not wash directly with water.
1.After washing cycle has finished,turn off the water faucet.(If needed,you can remove
the water inlet hose).
2.Do not store water in the washing machine for a long period without completing a
wash cycle.Drain the water completely after each wash.
3.Be sure to pull off the power plug before maintenance.
4.Hang up the power cord and drain hose.
5.Wipe off any drops of water on the surface of the machine and inside the tub.Leave
the lid open for about 1 hour after each wash to evaporate any residual water.
Wipe with a neutral detergent(please check
directions on detergent bottle first).
Do not wipe machine with thinners,petrol,
alcohol or other harsh solvents.
Figure 1 Figure 2
14
Clean the pump filter
1.Place a rag under the washer filter
not to wet the floor.
2.Rotate the filter counter clockwise
and pull out the filter.
3.Remove dirts and rotate
the filter clockwise
until it locks in
position.
Pump drained washer
1.Turn the filter-cap to the left.
2.Take the filter out and remove dirts.
3.Reassemble in
reverse order.
Loading ...
Loading ...
Loading ...