Loading ...
Loading ...
Loading ...
Preparation for setup
Before installation, be sure to have the following:
TV/PC monitor (Not laptop or all in one computer), with 1080P or higher resolution.
VGA or HDMI cables for connection to the TV/PC monitor.
Router (WAN) and Internet Service (for remote viewing)
If you purchased the system without a hard drive, you will need a hard drive if you
wish to record videos from the cameras.
Installing a Hard Drive (Skip this section if a hard drive was pre-installed)
Hard Drive Specifications: 4TB maximum, internal, SATA Interface, 3.5/2.5 inches
Please power off the NVR before installing the hard drive.
NOTE: A newly installed Hard Drive needs to be formatted before
recording. More information can be found at FAQ Part below.
1
Camera System Installation
Remove the cover from the unit,
and remove the top two screws
Remove the cover
Insert the hard drive, secure it
to the bottom of the unit with the
four screws
Connect the data wire and
power wire as shown
Replace the cover and fasten screws
03
Loading ...
Loading ...
Loading ...