Loading ...
Loading ...
Loading ...
13
B O S C H
* Model dependent
Do not use descaling agents for rinsing
out the boiler, as they could damage it.
If the “
” icon ashes (three beeps
may be heard at the same time), this
indicates that the boiler must be rinsed.
Please proceed as follows:
5
x2
8
9
1
~2 h.
ºC
2
3-4
7
0,25 L.
6
1. Check carefully that the appliance is
cold and unplugged for more than 2
hours, and that the water tank (1) is
empty.
2. Fix the iron to the base by inserting
the tip of the iron into the front slot
and moving the SecureLock lever
(10) against the heel of the iron.
3. Place your appliance over a sink or
bucket.
4. Lean the appliance on the opposite
side of the lter opening.
5. Unscrew the lter (12) and take it out.
6. To wash the lter, you may:
a. Place the lter under the water tap
and wash it until calc residues are
removed. Squeeze the lter as
indicated in the picture 6.
b. Immerse the lter in tap water
(250 ml) mixed with a measure
(25 ml) of descaling uid. Rinse
lter thoroughly before placing it
back into the boiler.
The descaling uid can be obtained
from our After-sales service or from our
website.
Accessory code
(After-sales)
Name of
accessory
(Online shop)
311144 TDZ1101
7. Holding your steam generator in the
lateral position and using a jug, ll
the boiler with 1/4 litre of water and
replace the lter.
8. Shake the base unit for a few
moments, unscrew the lter again
and empty the boiler completely over
a sink or bucket.
For best results, we recommend that
this operation is performed twice.
Important: before re-closing, make
sure no water remains in the boiler.
9. Replace and tighten the lter.
To reset the “clean” counter, switch
the station on and off twice, keeping it
off for at least 30 seconds each time.
(on → 30s off → on → 30s off → on)
Loading ...
Loading ...
Loading ...