Loading ...
Loading ...
Loading ...
1. Insert the tube until you can see only one of
the lines printed on the tube.
2. After inserting, pull the tube to ascertain that it
is secure.
3. Assemble the clip.
REFRIGERATOR INSTALLATION
Replacing Refrigerator Door:
❿❿
Right Door
• Lower the door onto middle hinge pin (8).
• Make sure the plastic sleeve is inserted in the
bottom of the door.
• Fit top hinge (6) over hinge lever latch (7) and
into place. Rotate lever (5) counterclockwise to
secure hinge.
• Install the grounding screw (4) and connect wire
harnesses (3).
• Hook tab on door switch side of cover under
edge of wire opening in cabinet top.
Position cover (2) into place. lnsert and tighten
cover screw (1).
❿❿
Left Door
• Lower the door onto middle hinge pin (9).
• Fit top hinge (7) over hinge lever latch (8) and
into place. Rotate lever (6) clockwise to secure
hinge.
• Install the grounding screw (5) and connect the
three wire harnesses (4).
• Push the water supply tube into the hole on the
top case and pull it out on the backplate.
• Insert the water supply tube (3) into the
connector tube until you see only one scale
mark. (Fully insert the tube over 5/8” (15mm)).
• Hook tab on door switch side of cover (2) under
edge of wire opening in cabinet top.
Position cover into place. Insert and tighten
cover screw (1).
16
(8)
(9)
Correct
Incorrect
ww
CAUTION
Collet
Insert Line
Clip
Tube
Loading ...
Loading ...
Loading ...