Loading ...
Loading ...
Electronically- controlled Variable Load – Fuzzy Logic
This machine has electronics that automatically process all stages of the wash to ensure exceptional results and at the same time save you time and money.
Once a programme has been selected, the machine optimises the following elements depending on the wash load and type of fabric:
- quantity of water and power consumption
- wash time
- rinse efficiency
The washing machine also:
- detects suds and increases the amount of rinse water if necessary
- adjusts spin speed according to load distribution, thus forestalling any imbalance in the mechanism.
Specific / special programmes
SPECIAL RINSE PROGRAMME :
Programme runs 3 rinses with a final spin (this speed may be reduced or spin cancelled using the appropriate button).
It works for all fabrics and can be used, e.g. after garments are hand washed.
SPECIAL HIGH-SPEED SPIN PROGRAMME :
Programme runs a spin at the speed indicated in the programme table.
EMPTY ONLY :
Programme empties the water from the machine.
HAND WASH :
The programme runs a complete wash cycle for garments intended to be hand washed. It washes at no more than 40 ºC and finishes with
three rinses and a delicate spin.
SILK :
This washing machine also has a gentle Silk and Hand Wash programme cycle. This programme allows a complete washing cycle for garments
specified as ‘Hand Wash only’ and laundry items made from Silk on the fabric label.
The programme has a maximum temperature of 40° and concludes with 3 rinses and no final spin.
ActivEco20ºC
EcoMix20ºC
ActivEco20ºC/EcoMix20ºC:
This innovative programme, allows you to wash different fabrics and colours together, such as cottons, synthetics and mixed
fabrics at only 20°C and provides an excellent cleaning performance.
Consumption on this program is about 40% of a conventional 40°C cottons wash.
EXPRESS
44´ MINUTE EXPRESS PROGRAMME
30´ MINUTE EXPRESS PROGRAMME
These programmes run a complete wash cycle at 40/50 ºC for up to 3.5 kg of washing in 44/30 minutes.
REMARKS
1. For heavily soiled washing we recommend loads of no more than 4 kg.
2. The machine is designed to apply fabric softener automatically in the last rinse of all wash cycles.
General recommendations
CLEANING AND MAINTENANCE OF THE MACHINE
Do not use abrasives, spirits or solvents when cleaning the exterior of the washing
machine. It is sufficient to use a damp cloth.
The washing machine requires very little maintenance.
• Drying the rubber seal of the drum.
• Cleaning the dispenser and its compartments.
• Cleaning the filter.
• Cleaning prior to removals or when the machine is to stand idle for long periods.
To help conserve the washing machine, dry the rubber seal and leave the door
open when the cycle ends.
CLEANING THE FILTER
The washing machine comes with a special filter, located
behind the machine’s front plinth panel, that collects larger
objects (coins, buttons, etc.) which could even block the
pump.
It is advisable to clean the filter whenever the machine fails
to rinse the clothes as well as it should or when it fails to
drain properly.
When it is necessary to clean the filter, proceed as
follows: 1,2,3,4,5,6,7.
• Use a basin to collect the water coming out.
• Remove the filter and clean it.
• Once the filter is clean, replace it by following the
above mentioned pro in reverse.
CLEANING THE DETERGENT DISPENSER AND ITS COMPARTMENTS
.- It is advisable to clean the three compartments of the detergent dispenser (pre-wash,
wash, and fabric conditioner) from time to time. To do this, remove the detergent
dispenser and after cleaning it, fit it back in place.
To remove and fit the detergent dispenser, follow the steps indicated in the images.
removing
.- Press button (A)
.- Hold down the button and turn the detergent dispenser outwards
.- Remove the dispenser and clean it
.- In the case of the pre-wash (I) and wash (II) compartments, it is advisable to remove
any dried-in remains of detergent which obstruct the flow of the detergent to the drum
.- In the case of the fabric conditioner compartment, the trap (S) located at the rear
part of the dispenser should be removed by pulling them out.
Remove any solid residue which could block the holes in the compartments.
fitting
.- Fit in the tabs as shown (B)
.- Turn the detergent dispenser towards the housing (C) in the door until the tab
clicks into place.
1
2 3
4
5
6
7
A
II
I
S
B
C
Loading ...