809960 & 820037 - Wolf 27'' Microwave Trim Kit
Installation Instructions For MWCTRIM27
815099 / Rev B / September 2011
PROCEDURE:
1. Locate properly grounded 3-prong receptacle
within 4” (102mm) from the right side and 4”
(102mm) up from the bottom of the microwave
oven cabinet.
2. The floor of the opening should be constructed of
plywood strong enough to support the weight of
the oven and floor load (about 100lbs/.45kg). The
floor should be level for proper operation of oven.
Be sure to check local building code as it may
require that the opening be enclosed with sides,
ceiling and rear partition. The proper functioning
of the oven does not require this enclosure.
T
OP & BOTTOM DUCT INSTALLATION:
1. Lining up the feet of the microwave with the holes
in bottom duct assembly, place microwave on the
assembly (See Figure 1).
2. Assemble the top duct assembly (See Figure 2).
3. Remove the existing screws from the upper right
and left rear of the back of the microwave (See
Figure 3).
4. Place the top duct assembly on the microwave.
Reinsert screws removed earlier, through assem-
bly into original screw holes (See Figure 3).
CONT
AINS:
QTY DESCRIPTION
6 Screws, #6-18x1''
2 Screws, #8-15x1/2'' Truss HD
1 Top Duct Assembly
1 Bottom Duct Assembly
Page 1 of 2
QTY DESCRIPTION
2 Panels, Decorative Trim
1 Frame Assembly
1 Installation Instructions
Install the MWC24 with a 120V, 60Hz, on a dedicat-
ed circuit. This outlet must be checked by a quali-
fied electrician to see if it is wired with correct polar-
ity and is correctly grounded. A GFCI outlet is not
recommended as this may cause product operation
interruptions.
Feet of Microwave
sit in these holes
Figure 1. Bottom Duct Assembly
Figure 2. Top Duct Assembly
Used for
Trim
1” Deep
Used for
Trim >1-1/8”
Deep
Figure 3. Attaching Top Duct to Microwave
Bottom Duct
Assembly
Back View
Top Duct
Assembly
Loading ...
