Loading ...
Loading ...
Loading ...
20
One-touch play
If you enable One-touch play, the TV
automatically switches to the correct channel
when you play a disc in your home theatre.
One-touch standby
When you press and hold
(Standby) on the
remote control, the home theatre and all the
connected HDMI-CEC devices (that support
one-touch standby) switch to the standby
mode.
If one-touch standby is enabled on your home
theatre, you can switch to standby with the
remote control of the TV or other HDMI-CEC
devices.
System Audio Control
When you play a device that has its audio
output routed to the home theatre, the home
theatre switches to the corresponding audio
source automatically.
To use one-touch audio, turn on System Audio
Control and follow the instructions on the TV
to map connected devices to the audio input
connectors of the home theatre.
Audio Input Mapping
When you connect a new device to your home
theatre, map the device to the audio input
connector (see ‘Play audio from home theatre’
on page 20).
Play audio from home theatre
Play the audio from a connected device through
your home theatre.
1 Press (Home).
2 Select [Setup], and then press OK.
3 Select [EasyLink] > [System Audio
Control] > [On], and then press OK.
• To play the audio from the TV
speakers, select [Off] and skip the
following steps.
4 Select [EasyLink] > [Audio Input Mapping],
and then press OK.
5 Follow the instructions on the TV to map
the audio of the connected device to the
audio inputs on your home theatre.
Note
•
If you connect your home theatre to the TV
through an HDMI ARC connection, make sure
that the TV audio is mapped to the ARC input
on your home theatre.
MP3 player
Connect your MP3 player to play your audio les
or music.
What you need
• An MP3 player.
• A 3.5-mm stereo audio cable.
Play music
1 Connect the MP3 player to the home
theatre as described in the Quick start
guide.
2 Press AUDIO SOURCE repeatedly until
‘MUSIC I-LINK’ appears on the display
panel.
3 Press the buttons on the MP3 player to
select and play audio les or music.
EasyLink
The home theatre supports Philips EasyLink, which
uses the HDMI-CEC (Consumer Electronics
Control) protocol. EasyLink-compliant devices that
are connected through HDMI can be controlled
by a single remote control.
Philips does not guarantee 100% interoperability
with all HDMI-CEC devices.
What you need
• HDMI-CEC compliant devices.
• An HDMI connection between the
connected devices.
Switch on
1 On the TV and other connected devices,
turn on the HDMI-CEC operations. For
details, see the manual of the TV or other
devices.
2 Press (Home).
3 Select [Setup], and then press OK.
4 Select [EasyLink] > [EasyLink], and then
press OK.
5 Select [On], and then press OK.
Control devices
Control the home theatre and the other
connected HDMI-CEC compliant devices with a
single remote control.
EN
Loading ...
Loading ...
Loading ...