Loading ...
Loading ...
Loading ...
Sensor Microwave Features
29-6290 15
USING YOUR OVEN: Sensor Microwave Features
To cancel, press and hold Stop/Cancel for 3 seconds. LOCK indication disappears.
CLEAR AND CARE
Exterior
The outside surface is pre-coated steel and plastic. Clean the outside with mild soap and water; rinse and dry with
a soft cloth. Do not use any type of household or abrasive cleaner.
Door
Wipe the window on both sides with a damp cloth to remove any spills or spatters. Metal parts will be easier to
maintain if wiped frequently with a damp cloth. Avoid the use of spray and other harsh cleaners as they may stain,
streak or dull the door surface.
Control Panel
Care should be taken in cleaning the press control panel. If the control panel becomes soiled, open the oven door
before cleaning. Wipe the panel with a cloth dampened slightly with water only. Dry with a soft cloth. Do not scrub
or use any sort of chemical cleaners. Close door and press STOP/CANCEL.
Interior
Cleaning is easy because little heat is generated to the interior surfaces; therefore, there is no baking and setting
of spills or spattering. To clean the interior surfaces, wipe with a soft cloth and warm water. DO NOT USE ABRA-
SIVE OR HARSH CLEANERS OR SCOURING PADS. For heavier soil, use baking soda or a mild soap; rinse
thoroughly with hot water.
Waveguide Cover
The waveguide cover is located on the ceiling in the oven cavity. It is made from mica so requires special care.
Keep the waveguide cover clean to assure good oven performance. Carefully wipe with a damp cloth any food
spatters from the surface of the cover immediately after they occur. Built-up splashes may overheat and cause
smoke or possibly catch re. DO NOT REMOVE THE WAVEGUIDE COVER.
Odor Removal
Occasionally, a cooking odor may remain in the oven. To remove, combine 1 cup water, grated peel and juice of
1 lemon and several whole cloves in a 2-cup glass measuring cup. Boil for several minutes using 100% power.
Allow to set in oven until cool. Wipe interior with a soft cloth.
Turntable/Turntable Support
The turntable and turntable support can be removed for easy cleaning. Wash them in mild, sudsy water; for stub-
born stains use a mild cleanser and non-abrasive scouring sponge as described above. They are also dishwash-
er-proof. Use upper rack of dishwasher. The turntable motor shaft is not sealed, so excess water or spills should
be wiped up immediately.
Grease Filters
Filters should be cleaned at least once a month. Never operate the fan or oven without the lters in place.
Pull down slightly on the tab toward the front of the oven and remove the lter. Repeat for the other lter.
Loading ...
Loading ...
Loading ...