Loading ...
Loading ...
Loading ...
Rinnai 8 Dry-Soft® RD-400/600AU Operation Manual
CARE AND MAINTENANCE
CLEANING THE AIR INLET FILTER
The air inlet filter is located at the bottom of the
appliance. Pull it out as shown.
Remove any dust from the air filter by using your
hands, a soft cloth or a soft brush as shown.
If removal of the lint proves difficult, the air filter
may also be cleaned with the assistance of COLD
water and a soft cloth or brush.
After removing dust, re-insert the air inlet filter. The
sides of the filter are located and guided by rails at
the bottom of the dryer body.
If water is used to clean the air filter, then it
MUST BE thoroughly dried before it can be
re-installed.
CLEANING THE HEATER BODY
Unplug the electrical cord before cleaning. All external parts of the appliance can be cleaned using a
soft, damp cloth and mild detergent.
DO NOT USE SOLVENTS FOR CLEANING THIS APPLIANCE.
SAFETY DEVICES
For your safety and peace of mind the Dry-Soft® range of gas clothes dryers are fitted with following
safety devices:
Flame failure sensing
Appliances shuts down in case of flame failure.
Drying drum overheat switch
Appliance shuts down in case the drying drum overheats. Self resetting.
Electric motor overheat switch
Appliance shuts down in case the motor overheats. Self resetting.
Drum Belt safety switch
Appliance shuts down in case of drum belt breakage.
Door Switch
Appliance cannot start unless appliance door is properly closed.
Blocked filter warning
Filter indicator lights up in case of blocked filter(s).
Electric Fuses
Protects appliance in case of electrical overload.
8
9
10
CAUTION
DO NOT
Loading ...
Loading ...
Loading ...