Loading ...
Loading ...
Loading ...
English 17
Installation instructions
4-Wire Cable from Power Supply to 3-Wire Cable from Cooktop
IMPORTANT: Use the 4-wire cable from power supply where local codes do not permit
connecting the frame-ground conductor to the Neutral (N) junction box wire.
A
B
C
D
E
G
H
I
F
A. 4-wire cable from power supply
B. L1 wires
C. Ground (G) or bare ground wire (from
cooktop)
D. 3-wire cable from cooktop
E. Junction box
F. N (normally White) wire (from power
supply)
G. UL listed wire connector
H. L2 (normally Red) wires
I. UL listed or CSA approved conduit
connector
1. Disconnect power.
2. Remove Junction box cover if present.
3. Connect the flexible cable condult
from the cooktop to the junction box
using a UL listed or CSA approved
condult connector.
4. Tighten screws on condult connector,
if present.
5. Connect the two L2 wires together
using the UL listed wire connectors.
6. Connect the two L1 wires together
using the UL listed wire connectors.
7. Connect the Ground (G) or bare ground
wire from the cooktop cable to the
Ground (G) or bare ground wire (in the
junction box) using a UL listed wire
connectors.
8. Put a UL listed wire connector on the
end of the Neutral (N) wire.
9. Install junction box cover.
10. Reconnect power.
NOTE
• Usually L1 is Black, L2 is Red, Ground (G) is Green or bare wire and Neutral (N) is White
wire.
• Do not connect the bare ground wire to the Neutral (N) wire in the junction box.
NZ9500K_MOD_DTI30M977B_DG68-00898A-00_EN+MES+CFR.indb 17 2017-04-05 3:02:29
Loading ...
Loading ...
Loading ...