Loading ...
Loading ...
Loading ...
Page 5
Cabinet Installation
First install deector to the bottom of the Cabinet, then
install the Hood to the Deector:
1. Find the centerline of the cabinet bottom. Draw a line
along this centerline from rear to front of the cabinet.
2. Draw two lines, one at a 2
1
2“ distance from the wall,
the other one at a 7
1
16“ distance from the previous
line. Mark 4 points , two along each line at a distance of
half W from the center line, to determine the screw
locations.
7
1
/
16
W
CL
Screw for
cabinet
bottom
installation
2
1
/
2
W: RECHMWB36: 29
2
16(740 mm)
RECHMWB30: 34
15
16”(887 mm)
3. Fit 4 screws on cabinet bottom (screws not supplied) do
not tighten completely but leave a space of about
1
2
from cabinet bottom surface and head screws.
Note: the screws must be suitable to support the hood/
deector wieght and must be the right type according
with the bottom cabinet surface.
4. Hang the Deector on screws through side slots
provided on deector top. Tighten the four screws
through slots.
5. Fit four screws on bottom of the deector, do not
tighten completely.
6. Install the Hood on bottom of the Deector so that
screws and pins go respectively into Side Slots on
top of the hood and Side Slots on bottom of Deector,
slide the hood rearward until it stops.
7. Remove 1 of 2 knockouts and install
1
2“ conduit
connector in j-box.
8. Fit screws, from inside the hood to nal assembly
deector to the hood.
9. Proceed to install hood as described on the Installation
Manual.
Charcoal filter
In the recirculating mode, the air will be recirculated
through disposable charcoal lters that help remove smoke
and odors.
Remove the grease lter of the hood.
Cover the grill that protects the suction motor with the
charcoal lter so that the slots on the lter correspond
to the pins on the sides of the motor protection grill.
Turn the carbon lter clockwise to block them (bayonet
xing).
NOTE: The charcoal lters cannot be cleaned. Filters
should be replaced every 4-6 months (depending on hood
usage).
Loading ...
Loading ...
Loading ...