Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS - Licensed qualified installers only
These instructions are for the use of a qualified installer only! Warranty is immediately voided if
the cooker is not installed by a licensed gas fitter. It is the owner’s responsibility to ensure
that the installer is correctly licensed to complete installation. Faulty installations will not
be serviced and you may be subject to a call out fee if the cooker is found to be incorrectly
installed.
Statutory regulations
This appliance is to be installed in accordance with the manufacturer’
s installation instructions, lo-
cal gas fitting regulations, applicable building codes, electrical wiring regulations, and according
to the installation code for Gas Appliances AS/NZS5601. Consult SAA wiring rules as appro-
priate.
Safety Warnings About Installation
• The cooker must be installed and serviced by a qualified technician.
• A certificate of compliance must be supplied by the installer and kept by the customer.
• All packaging materials including protective plastic film must be removed before the
cooker is installed.
• The pipes or hoses used in installation must have sufficient slack to allow for the cooker to be
moved for service.
• The anti tilt brackets must be fitted.
• The cooker must not be lifted or pulled using the oven handle.
• The cooker must be serviced and checked at least every 3 to 4 years depending on usage or
condition.
Minimum Clearances
When the upright cooker is installed abutting a side or rear wall, the wall must be of non-com-
bustible material, eg ceramic tiles. The following minimum clearances to combustible materials
must be observed:
MINIMUM CLEARANCE FROM COOKTOP TO SIDE WALL MUST BE 200mm
KITCHEN CABINET WARNING
IF THE INCORRECT CABINET MATERIAL IS USED, OR THE DESCRIBED CLEARANCES NOT
COMPLIED WITH DURING INSTALLATION THEN THE CABINETS MAY BE DAMAGED DUE TO
HEAT TRANSFER FROM THE COOKER.
THE COOKERS ARE MADE TO MEET AUSTRALIAN STANDARDS FOR HEAT TRANSFER AND
SURFACE TEMPERATURES.
ALL ADJACENT SURFACES TO THE COOKER MUST BE ABLE TO WITHSTAND NORMAL
HEAT TRANSFER FROM THE COOKER, AND THE HEAT RELEASED FROM THE OVEN
DOOR WHEN OPENED.
GLEMGAS ACCEPTS NO RESPONSIBILITY FOR CABINET DAMAGE FOR DAMAGE TO
KITCHEN CUPBOARDS AND DRAWERS DUE TO INCORRECT INSTALLATION.
IF IN DOUBT INSTALL A HEAT SHIELD SUCH AS A THIN SHEET OF FIBROUS CEMENT
BETWEEN THE COOKER AND THE CUPBOARDS.
19
Loading ...
Loading ...
Loading ...