Candy CBO 150E Refrigerators

User Manual - Page 19

For CBO 150E.

PDF File Manual, 161 pages, Download pdf file

Loading ...
Loading ...
Loading ...
18
storage racks.
A malfunction may be caused by only a minor fault that you can rectify yourself using
the following instructions. Do not perform any other work on the appliance if the
following information does not provide assistance in your specific case.
Important!
Repairs to refrigerators/freezers may only be performed by competent service
engineers. Improper repairs can give rise to significant hazards for the user. If your
appliance needs repairing, please contact your specialist dealer or your local Service
Force Center.
Symptom Possible Cause Remedy
Appliance is not switched on. Switch on the appliance.
Mains plug is not plugged in or is
loose.
Insert mains plug.
Fuse has blown or is defective. Check fuse, replace if
necessary.
Appliance does not work.
Socket is defective. Mains malfunctions are to be
corrected by an electrician.
Appliance cools too much. Temperature is set too cold. Turn the temperature
regulator to a warmer setting
temporarily.
Temperature is not properly
adjusted.
Please look in the “initial Start
Up” section.
Door was open for an extended
period.
Open the door only as long
as necessary.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
Turn the temperature
regulation to a colder setting
temporarily.
The food is too warm.
The appliance is near a heat
source.
Please look in the “installation
location” section.
Interior lighting does not
work.
Light bulb is defective. Please look in the “changing
the Light Bulb “section.
Heavy build-up of frost,
possibly also on the door
seal.
Door seal is not air-tight(possibly
after reversing the door).
Carefully warm the leaking
sections of the door seal with
a hair dryer(on a cool
setting). At the same time
shape the warmed door seal
by hand such that it sits
correctly.
Appliance is not level. Readjust the feet.
The appliance is touching the wall
or other objects.
Move the appliance slightly.
Unusual noises.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
If necessary, carefully bend
the component out of the
way.
The compressor does not
start immediately after
changing the temperature
setting.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
Water on the floor or
storage shelves.
Water drain hole is blocked. See the “cleaning and care”
section.
Loading ...
Loading ...
Loading ...