Loading ...
Loading ...
Loading ...
17
The supplied Remote Control performs the various
Operating Functions for the C8 Preamplifier.
Input Source Selection
Press the Push-button → to select the desired
program source.
Volume
Press the + or - Push-buttons to increase or
decrease the listening level.
Mute
Press the (Mute) Push-button to mute the audio and
a second time to resume listening.
Select Push-Button
Press the SELECT/TRIM Push-button to activate the
Trim Mode. Then use the Directional Push-Buttons to
select a Trim Mode Function and make changes.
Directional Push-Buttons
After having pressed the SELECT Push-button,
press the ▲ ▼ (Up or Down) Push-buttons to scroll
through the various Trim Functions. Then press the
◄ ► (Left or Right) Push-buttons to make a change
to the current Trim Setting.
Changing the Remote’s Baery
Someday, the AAA battery in the remote will need to
be replaced. This is how to do it.
The back of the remote control is held in place by
magnets. To remove the back of the remote to reveal
the battery, slide the front of the remote up while sliding
the back of the remote down. The goal is to move the
back 3/16 of an inch from the top of the remote and
then lift it off. There are many ways do to this, as far as
positioning your ngers. To open the remote:
• Hold the remote upsidedown and backwards with
McIntosh name upsidedown and facing away
from you. The thicker end will now be the top and
you should be staring at the back of the remote.
• Pinch the remote with your index nger resting on
the SELECT/TRIM button and your thumb on the
backside (facing you) opposite your index nger’s
position. Your thumb and remote should both be
pointing away from you (see Figure 13).
• Use your thumb to slide the back open 3/16 of an
inch. Slide your thumb away from you towards
the thicker end of the remote, while your index
nger goes in the opposite direction (towards
you). As if snapping your ngers in slow motion.
For added strength, you can use your other hand
in a similar position above your rst hand using
the same technique. Make sure you do not hold
the side edge with either hand.
• Lift the back off with your other hand before it
snaps closed again. You can grab the now exposed
top edge.
• It gets easier after the rst time.
Remove and replace the battery noting the polarity
(printed below the battery if you forget).
To replace the back: Place the back in position 3/16 of
an inch from the edge. The magnets will help you snap
it back into place.
.
Figure 13– Opening the Remote Control
Loading ...
Loading ...
Loading ...