Loading ...
Loading ...
Loading ...
E-Panel Instructions (continued)
4 | P a g e 1 0 - 0 7 0 - 1 R E V : A
Torque – Ground Box Lug
10AWG 20 in-lbs (2.3Nm)
8AWG 25 in-lbs (2.8Nm)
6AWG 35 in-lbs (4.0Nm)
4AWG 45 in-lbs (5.1Nm)
2AWG – 1/0 50 in-lbs (5.6Nm)
Torque – Circuit Breaker to 75 in-lbs (8.47Nm)
Re-torque after 1 hour
Quad Enclosure
Installation:
Select a safe dry indoor or sheltered location and secure to the wall with appropriate screws or wall anchors.
Wiring:
The MNEDC Quad is a general purpose enclosure that may be used with up to 4 panel mount AC or DC breakers.
Midnite Solar breakers available at your local dealer are highly recommended such as Midnite Solar part number MNEDCXX
Circuit Breakers, where XX is the breaker value, for example: MNEDC10 = 10 amps. Use Breakers rated for 300 VDC or 277
VAC max.
The MNEDC Quad is designed for breakers up to 65 amps and wire up to 6 AWG.
If you decide to use larger breakers and wire this will affect the required bending room for wiring. The wiring area gets pretty
tight with all four breakers installed and 4 AWG wire. A box lug is provided for grounding of the enclosure. Knockouts are
provided at the top and bottom of the Quad enclosure. You will need a hammer, screwdriver and needle nose pliers to remove
knockouts.
Note: It is the installer’s responsibility to ensure compliance the National Electrical Code, ANSI/NFPA 70 and all applicable
local codes
Breaker knockouts
(Breakers not included)
Removable front for easy installation
MNEDC QUAD
Bottom view