Loading ...
Loading ...
For Mounting MTC-CBT-SUS3 On Top and Bottom of
CBT 1000 Speaker or CBT 1000+1000E System
The MTC-CBT-SUS3 suspension bracket can be mounted to the top and bottom of the CBT 1000 and CBT
1000 + 1000E System if desired. Special hardware in included in the kit that is designed for use with this
bracket mounting place (M8 x 40 mm x8) and it is the only hardware that can be used for this purpose.
Orienting the top bracket with the Clip Points toward the front of the speaker, the speaker will tend to tilt slightly
forward, allowing full adjustability of the tilt-back angle using the second bracket at the bottom of the back
panel of the speaker, or using the second bracket on the bottom end-cap with the Clip Points toward the back
of the speaker.
Step 1: Remove the four screws on the top and bottom end caps from the CBT 1000 (or the top end cap from
the CBT 1000 and the bottom end cap from the CBT 1000E if you are preparing to mount the system after you
have attached the two speakers with the connector plate).
Step 2: Use the M8 x 40 mm PAN HEAD BOLTS to secure the MTC-CBT-SUS3 brackets to the top and/or
bottom of the plastic end cap, as shown.
Step 3: Suspend the attached suspension bracket system via the 15 mm (0.62 in) Clip Points located on the
30 degree bend on each bracket. Be sure to consult the building codes in your area to determine the proper
materials and procedures.
Caution: Be sure the building’s structural mounting points are structurally capable of supporting the weight of
the speaker assembly with the required safety ratio. If you have any doubts about the capability, supplies, or
method, consult with a licensed suspension expert.
M8 x 40 mm PAN HEAD BOLT
LOCK
WASHER
FLAT
WASHER
4 PLACES per Bracket:
Shown with the Clip Points toward the
front of the speaker. Can also be installed
with Clip Points toward the back. Consult
with a professional as to which is most
appropriate for your application.
Loading ...