Loading ...
Step 2: Position the brackets on the back of the speaker so they use the four insert points closest to the top
and bottom of the box (see drawing). Make sure that the at washers and the lock washers included are used
as shown. Utilize 4 bolts per bracket (total of 8 bolts for top and bottom bracket).
When the speaker is installed in upright orientation, orient the 15 mm (0.62 in) Clip Points (on the 30 degree
bend of each bracket) at the top for the top bracket (as the main load points) and at the bottom for the bottom
bracket (as a pull back for aiming). For other orientations, consult a licensed structural engineer.
Step 3: Suspend the attached suspension bracket system via the 15 mm (0.62 in) Clip Points located on the
30 degree bend on each bracket.
Be sure to consult the building codes in your area to determine the proper materials and methods. Be sure
the building’s structural mounting points are capable of supporting the weight of the speaker assembly with the
required safety ratio. If you have any doubts about the materials, methods, or structural capability, consult with
a licensed structural engineer.
PAN HEAD BOLT
M6 x20 mm or M8 x 20 mm
(depending on speaker model,
see diagram on page 1)
LOCK
WASHER
FLAT
WASHER
8 PLACES (4 per Bracket):
CBT 1000 shown Assembled
Loading ...
Loading ...