Loading ...
Loading ...
Loading ...
20 Outdoor Unit
Installation
Foundation for Installation
• Fix the unit tightly with bolts as shown below so that unit will not fall down due to earthquake or gust.
• Use the H-beam support as a base support
• Noise and vibration may occur from the floor or wall since vibration is transferred through the installation part
depending on installation status. Thus, use anti-vibration materials (cushion pad) fully (The base pad shall
be more than 200mm(7-7/8 inch).
At least 200mm
(7-7/8 inch)
At least 10mm
(13/32 inch)
Unit : mm(inch)
75(2-15/16)
75(2-15/16)
100(3-15/16)
200(7-7/8)
200(7-7/8)
Ⓐ The corner part must be fixed firmly. Otherwise, the
support for the installation may be bent.
Ⓑ Get and use M10 Anchor bolt.
Ⓒ Put Cushion Pad between the outdoor unit and ground
support for the vibration protection in wide area.
Ⓓ Space for pipes and wiring (Pipes and wirings for bottom
side)
Ⓔ H-beam support
Ⓕ Concrete support
WARNING
• Install where it can sufficiently support the weight of the outdoor unit.
If the support strength is not enough, the outdoor unit may drop and hurt people.
• Install where the outdoor unit may not fall in strong wind or earthquake.
If there is a fault in the supporting conditions, the outdoor unit may fall and hurt people.
• Please take extra cautions on the supporting strength of the ground, liquid outlet
treatment(treatment of the liquid flowing out of the outdoor unit in operation), and the passages of
the pipe and wiring, when making the ground support.
• Do not use tube or pipe for liquid outlet in the Base pan. Use drainage instead for liquid outlet.
The tube or pipe may freeze and the liquid may not be drained.
WARNING
• Be sure to remove the MDF(wood support) of the bottom
side of the outdoor unit Base Pan before fixing the bolt.
It may cause the unstable state of the outdoor
settlement, and may cause freezing of the heat
exchanger resulting in abnormal operations.
• Be sure to remove the MDF(wood support) of the bottom
side of the outdoor unit before welding. Not removing
MDF causes hazard of fire during welding.
Pallet(Wood Support)
- Remove before Installation
Loading ...
Loading ...
Loading ...