Loading ...
Loading ...
Loading ...
Before using for the first time
29
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage is set in stages
from 0 to 6. It is set to 3 at the factory.
This is the recommended setting.
If the "Adjust Automatic" programme
function (depending on model) has
been activated, the amount of rinse aid
dispensed in the Automatic programme
can be higher than that set.
If spots appear on crockery and
glassware:
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
Decrease the rinse aid dosage.
Switch the dishwasher off with the
button, if it is switched on.
Press the programme selector
button in and, whilst holding it in,
switch the dishwasher on using the
button.
Keep the programme selector
button pressed in for at least four
seconds until the lower right-hand
programme indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the button three times.
The indicator will flash rapidly 3
times at intervals.
The dosage set will appear in the
display after .
The flashing sequence will appear in
the display.
This indicates the factory default setting
3.
Use the programme selector
button to select the setting
required.
Each press of the button moves you
up a level.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
Loading ...
Loading ...
Loading ...