Loading ...
Loading ...
Loading ...
11
OPERATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packaging
Before connecting the appliance to a power source and operating, let the unit stand upright for a minimum of 4
hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
SWITCHING ON/OFF THE AIR CONDITIONER
The appliance can be switched ON or OFF by pressing the POWER button on the control panel or the ON/OFF but-
ton on the remote control
COOLING MODE
In this mode, the air conditioner cools and dehumidifies the room. To activate this function mode, press the Mode
Control until the Cooling indicator light comes on. When the cooling mode is set, the compressor will start in ap-
proximately 3 minutes. In cooling mode, hot air is exhausted from the outdoor exhaust port and the exhaust hose
must be connected to exhaust out the hot air.
The temperature setting range of this air conditioner is from 61°F / 16°C to 89°F / 32°C. To set the temperature,
press the or buttons. This air conditioner has a 5°F temperature cushion which if the set temperature is within
5°F of the ambient temperature, the unit runs on fan only mode. This saves energy and prolongs the life of the com-
pressor of the air conditioner.
To set the fan speed, press the FAN button. In cooling mode, the difference in noise level between the 3 fan speeds
is not very noticeable when the compressor is on. Try setting the unit to Fan only mode, you should be able to hear
the difference between high and low fan speed settings.
DEHUMIDIFYING ONLY MODE
In this mode, the air conditioner only dehumidifies the room, the compressor will activate intermittently depending on
the ambient temperature and the fan speed is set to LOW. To activate this function mode, press the Mode Control
until the Dehumidifying indicator light comes on. Please note that when switching functions, there will be an
approximate 3 minute transition time. In dehumidifying mode, the exhaust hose does not need to be vented. If the
exhaust hose is vented, the room will be cooled as it dehumidifies. To prevent cooling, remove the exhaust hose
from the window kit and allow the warm air from the rear to be re-circulated into the room. If room temperature is
higher than 77°F, the fan speed can be adjusted. If room temperature is lower than 77°F, the fan speed is set at
Low.
NOTE: When using Dehumidifying mode, venting the exhaust hose to the outside is not required. If vented, the
warm air is exhausted to the outside and cooling within the room may occur. Additionally, if the exhaust hose is not
vented, the unit may require more frequent draining. The air conditioner does not have a humidistat in which a
specific humidity level can be set.
FAN ONLY MODE
In this mode, only the fan of the air conditioner runs and circulates the air in the room. To activate this function mode,
press the MODE button until the Fan indicator light comes on. In this function mode, the temperature cannot be set.
Subsequently, set the desired fan speed by pressing the Fan button. Fan Only mode does not require the use of the
exhaust hose.
Loading ...
Loading ...
Loading ...